Most Popular 6000 Lbs for 2017 Honda Odyssey

Who do I contact about getting the right extension bar? The one I ordered Is a 2 1/2 inch which I need a 2 inch to slide into my receiver or if you guys have a 10 to 12 inch, 2 inch extension so I can connect it I sent a photo of the end that is 2 1/2 which I need it to be 2 inches to slide into my receiver

Click to Enlarge

I recently swapped out the stock 2" receiver for a 2-1/2" to allow me to purchase and use this extension to get past the end of my Lance 1010 Camper. I believe I will have no issues now towing any trailer (within allowable spec's) or carrying my motorcycle carrier. Great quality piece. can't wait to try it out...

Click to Enlarge

This tow bar extension is a quality built product.. Very helpful backing a trailer.

I have included some photos of the hitch extension. The first two are just on my truck without and with the extension. Without the extension, note the proximity of bike handlebars to the tailgate. In the second photo with the extension, the handlebars are much removed from the tailgate. Note that this is a ¾ ton truck with an insert in the receiver. With the insert in place, the front holes of extension did not align with the receiver. It was short 1/8 to 3/16 inch. If needed, I could solve this issue with a smaller bolt. The next photos are without and with the extension in the receiver of our RV. With the cover on RV the dramatic effect of extension is not so obvious. In the first photo without the extension, the handlebars of bike literally contact the back of RV. In contrast in the second photo, the handlebars are 5 to 6 inches from the back of the RV. Though there are no road trips yet, I am confident that the hitch extension will protect the bike and importantly will protect the back of the RV. I hope that these comments and photos are useful to you. If no, I can try again in spring when we remove cover from the RV.

Click to Enlarge

Click to Enlarge

I had to remove burrs from the inside of the tube, both at the holes drilled (for hitch pin) and the end where the ball hitch goes in. The welded boss on the end of the tube had burs left over from the cutoff operation. The ball hitch would only slide in a couple of inches prior to deburring it. Also the packaging was not very good, see pictures. No damage to the product but I am surprised it even stayed in the box during the trip here, it was completely loose in the box and tore it apart during transport.

Click to Enlarge

Click to Enlarge

The product is good the packaging for shipping needs improvement. The box came ripped in half and only the tape on the bottom of the box was holding the box together. The plastic cap for the one end was broken and unusable. The other end had a dent in the metal that had to be filled down to be able to insert it into the receiver. The bracket for the plug extension to mount into the hitch extension was bent together so it had to be bent back straight. This was to be able to insert the plug and line up the 4 holes to be able to mount the receiver plug to the extension.