Most Popular Tinted for 2016 Ram ProMaster 2500

Bought two for my Promaster camper conversion and they work great

Great fan, I am extremely happy with the quality of the product and glad I chose etrailer for my purchase. I installed in a 2015 Promaster myself with no problems. After you get past the anxiety of cutting a hole in your roof, it goes smoothly.

Fan installation is very straightforward. Perfect fit and looks and works great. Hardest part was removing old caulk - plastic scraper and patience worked well for me.JUST TAKE YOUR TIME.

Fan arrived quickly and was an exact replacement for our Hail storm damaged unit. Thanks eTrailer!

Our hunt club has 2 pit blinds that are used for waterfowl hunting. Each blind is essentially a concrete box with walls, floor and top 4 inches thick and dimensions of 12'x5'x5'. Each blind is buried to a depth of 5 foot to where the top is flush with ground level. Access is through the top using 24 inch wide manhole lids that are made of high density plastic. The cooler air inside of the blinds clashing with warmer air absorbed by the concrete and manhole lids at ground level caused condensation that made the inside damp and smelly. We only hunt 3 months each year, so needed a vent solution for the other 9 months the blinds were not in use. We also needed something that could be powered by DC voltage from a solar panel due to the remote location. In July 2015 we installed each fan into a manhole cover and used water-tight conduit and electrical boxes to run the wiring from the solar panel to each fan. Great solution! Once enough daylight hits the solar panel the fan blades start moving and run constantly until sundown. Will see how long these things last but so far so good

My Maxxair fan was easy to purchase on etrailer.com. The shipping package came early and in excellent condition. Packaging was superior. I will be using the fan with my Promaster van build. I have purchased from etrailer before and will again as the need arises. My experience with etrailer is exceptional. I recommend them highly.

Very nice addition to my Seismic. Should have came already with the trailer since the trailer is $$$$$. The remote is crazy BIG and its wall mount cradle is not design for RV use. Leave the remote in the wall mount cradle while in transport will soon produce a ejected/broken remote :(

Fast shipping, good price!

Just installed, so no use experience yet. Need to add rear overhang dimensions to the specs. I hesitated to order because I couldn't confirm that it would clear my shower skylight, but it did fit!

This powered roof vent is great! I mounted it above the cab in my 1991 high-top conversion van to provide cool air when camping in it. Fan is more powerful than I expected! I rarely need to switch it to high speed. It's quiet enough for sleeping just a few feet away. Installation was easy and dimensions were accurate. Controls are easily accessible. Auto temp control is really nice when outdoor temps are dropping during the night so we don't get too cold. Rain sensor triggers to close cover after only a few drops of rain! Reversible fan is nice.

The (2)fan lid black plastic mounting bosses broke as if they had deteriored in the sun. This lower the lift arm to flop down and keep the lid from opening. Trying to figure a method to repair.

Great instructions. Very nice product. Installed nicely and looks beautiful. You will need to buy the butyl tape to properly install and of course the self leveling roof sealant.

This vent fan helps a lot with keeping my 7x14 cargo trailer cool. Did a lot of modifications with my trailer especially insulating the ceiling and now with this fan makes it better and cooler. The lid is always open to let the heat out because i have the MaxxAir II cover so rain cant get in. Fan runs better with more or bigger airflow from the side vents when all doors are closed so i added the Redline II popup vent and it works great. Fan does not slow down. Im glad i got this and will be purchasing again when i get another trailer. Thanks ETrailer

Vent was easy to install, really didn't need the instructions. I would have appreciated a template for the hole though. That way I can just throw the template up and cut along it. A recommendation to reinforce the underside with something (I used 2x2s) might be helpful as well. You do say to align it with a joist, but who's really going to have multiple joists within 14 1/2" from each other? Otherwise, it looks great. I figured you have multiple images of the vent itself so I figured an image of how I reinforced it would be the most helpful for future installers. Thank you. Aaron

Product material and build is solid. Easy to install. I like the smoke colored cover, lets in the right amount of sun (we dry camp in the Southwest a lot). The fit between screen and frame with the open/close knob was off by about 1/4 inch in depth. Was able to adjust the knob mounting position down so as to insure a tight fit between screen and beauty ring. We have an eighteen-year-old rig, so it is challenging to find replacement parts that fit as original. But it fits great now! great web site - easy to drill down to appropriate parts. Thanks again.

Whenever I am looking for accessories or parts for our RV or vehicles I first check to see if etrailer has the item. As usual etrailer service and shipping were excellent. The plastic vent covers were well packaged and arrived in excellent shape.

EXCELLENT! I bought this Maxxair Fanmate vent cover for my RV kitchen vent. Now I can leave the vent open without worrying about rain or bugs getting inside my 5th wheel. You can see through the smoke colored plastic like looking through a cool skylight. I bought two. One justed clipped on because it already had the Maxxair bracket installed from Grand Design. The other I will have to install the bracket that came with the vent cover! Looks Great!