# 1
Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - Smoke
Installed this vent into my Haulmark Transport 6'x12' enclosed trailer. Installation was easy, I cut a 14.25" x 14.25" inch hole between two crossmembers in the roof and dropped it in place. Because the roof on this enclosed trailer is so thin, I used a piece of 3/8" plywood so sandwich between the interior garnish and actual vent. I cut the same size hole into the plywood and left a 2" lip all around. I use 28 #8 x 5/8" stainless screws to hold it in place, pre-drilled with 1/8" bit. I then used roofing tar to seal the vent and put masking tape all around, leave 1" from the flange to ensure good coverage. I then removed the masking tape, leaving nice clean lines. Interior garnish is held in place by #8 x 3/8" galvanized screws. Huge kudos to etrailer for carrying such awesome products for great low prices and offering super cheap shipping to Canada!
So far it's holding up with no leaks. Kind of on the flimsy side comparing to the one removed but easy to install. Couldn't use the trim ring inside but after a year still looks new and the lifting/lowering mechanism works smoothly. Overall a good price for the quality.
# 2
Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - White
Perfect replacement for my 2012 Keystone Passport travel trailer.
Was missing the retaining clips on both items. The old ones were ok.
# 3
Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - Metal
Well made vent should last years. I like the removable screen for easy cleaning. Unfortunately the roof vent mounting flange is badly damaged. I will need to do some work with my hammer and anvil to make it useable. This is clearly incorrect/damaged.
I’m very pleased with the quality of the vent and how easy it is to open and close. This was a replacement for the previous vent that became inoperable and leaked.
What our customers are saying:
"very easy to shop"