Most Popular 2 Inch Ball for 2009 Hummer H3

Went with the B&W due to the length of the shaft going into the receiver. My 2024 Ram's receiver is recessed under the bumper. This hitch is long enough to accept my Towtector product. Similar to Rock Tamers. Also, Brittany in customer service was awesome to work with as she guided me towards the product that worked for my application.

This ball mount is extremely heavy duty. I had a stock class IV hitch and aftermarket ball mount on my Ram 3500 SRW and it was bending towing a 14000 lb dump trailer. I upgraded to a class V hitch and this mount and it's working great. I have 6 trailers that I pull with gooseneck, 5th wheel and ball hitches. The only 1 that uses 1 7/8" ball is a little 5x8 utility trailer that I'm converting to 2" so I got the 2 ball instead of the 3. When turned sideways it works as a step to get into the truck but only if the tailgate is up. It doesn't stick out far enough when the tailgate is open. The reason for 1 less star is the documentation; you need more information to make the best choice. I originally ordered a different PN and it hung way too low bc is mounted under the existing hitch. To remove the stock hitch, you also remove the integrated mounting brackets for the bumper. I ordered a PN for a truck without a hitch and cut off the receiver tube with a torch. Also, I upgraded the 3 1/2" exhaust to 4" and now at idle the exhaust rattles on the much larger frame of the class V but a slight modification in planned to take care of that. Installation was fairly straighforward once I removed the original receiver tube.

Great fit and finish looking forward to the first tow with it.

This is a must have for full-time trailer hauling. No ball grease needed. Easy to adjust for a level trailer, smooth towing. I increased my trailer tires to light duty truck tires (a little taller tire), for heaver loads & ease of mind to haul at 75 mph speed. This hitch allow me to fine tune the trailer ball height for best setup on my heavy duty Toyota Tundra truck.

Impressive quality!

Sooooo....you sent me a product that was somehow put together backwards and I cannot take them apart somehow the ballhitch is stuck on the male portion backwards and defies gravity and doesn’t need a pin to stay on(becaue thier is no where to put the pin in cause it’s backwards

The hitch and ball mount are excellent quality. My concerns are twofold. The hitch is so heavy that I had to take it to my mechanic to have it installed. Minor cost and inconvenience, but the hitch for my previous F-150 was just as sturdy, but easy to install myself (albeit with higher ground clearance). My concern about the ball mount is that the factory told me erroneously that it could not be reversed for a drop, so I returned it. This order is for the replacement after I was finally correctly told it could be reversed and how to do that. Ball mount would have been a 3 for that reason, and overall hitch and ball mount quality a 5. So I averaged them.

I have two of these. My first I bought two years ago. I very highly recommend this Curt Class III Ballmount 2" Drop because of its price, durability and quality. I towed various class 3 loads with ease and confidence with this ballmount. It slides into the hitch and does its job without fail. It looks excellent after towing a load. etrailer's price is about as good as it gets and delivery is very speedy.