Best 2003 Tiffin Allegro Motorhome Trailer Lights

Nice lights once you get them installed-They are bright and look nice on the 1970 Sears boat trailer. The wires that come out the back need a 3/4" hole to fit through-so I had to drill a 3/4" hole in the trailer plus the 2 mounting screws holes. I had as much $ in drill bits as I did with the lights

Shipping was fast, lights were easy to install and look great, really bright at night. The "bling" to top off paint-n-seal update we are in the process of doing on our 1983 travel trailer. The new LED's make the camper look good, friends thought we got a new one. Highly recommend them.

Parts are exact fit as I led parts

Exactly what I ordered and needed.

just what I needed--- easy installation, just remove the old light strip, put the new one in place , make your electrical connection, good to go---no special tools, you do need a stepladder to get up to the work area

Good product and lights up well. The glue could be a bit stronger than it is. Had a couple parts of the strips come loose when the weather got warm.

Exactly what I ordered and in a reasonable time.

This was a replacement for the OEM marker light installed by Jayco. It failed within the first year, probably because it was installed upside down(drain holes in the amber cover facing up…) the light assembly is marked TOP. Oh well! I did check the other three and they were installed correctly and are still working… With the OEM part number I matched it to this part from Etrailer. Confirmed dimensions and placed the order. Note the new light comes without screws.

The light assemblys ordered were back ordered but shipped to me as soon as they were available. The fit was perfect. Had some problems with the wiring,the coach had 8 wires and the assy had 6. Once figured out the install went quickly. Perfect match.

Command Triple LED Tail Light Review They work great once they are installed. I have 2002 Gulf Stream Ultra on a Ford E450 Frame. The problem is the actual installation. Command does not include install instructions. What may needed if converting from incandescent bulb to a LED system is a 12 Volt 50 Watt 6 Ohm resistor. Installing a resistor parallel between the Brake/signal and Common wire will be necessary to overcome the hyper-flasher bulb out detection system. This high power resistor needs to be mounted on a metal surface to help disapate the heat created. In my case, I mounted the resistor to 3/4 metal pipe banding. The resistor was suspended so that is would have great air flow. Furthermore, size of the light should be slightly larger than 14 w x 6 7/8 . In my case the tail light was not big enough to cover the old light screw holes. I made this work by centering the light and using lap sealant as a finishing water proof bead. After a long road trip and many signal turns and brake presses the tail lights do look and work great.

This part I received (#STL69RRXB 091523) turns out not to fit. Further, after taking off the existing part I find the part number is (#STL69RB 121821)

I'm very happy with the product. It was exactly what I was looking for at a fair price with fast shipping. It was the exact replacement for my legend v20 trailer tail lights. I appreciate the customer who posted the review and picture of his legend v20 trailer. I had been looking for this part for a long time and wanted to insure that I found the right parts. Thank you.