Most Popular Rearview Mirror Monitor for 2000 Chevrolet Suburban

My wife rode with a friend for lunch who had a new car with a back-up camera. She was really impressed and was talking about buying a new car to replace her 2011 Ford Escape that would have the backup camera. I found a video showing how to install the camera on an Escape by etrailer. I was impressed by the company and bought a unit. It arrived quickly and I was able to install it following the instructions I had watched. It took me a couple of hours to install, the hardest part being fishing the cables to the rear of the car. Once installed it worked great. My wife is very, very happy with the install. She says she is much more confident in parking her car. Thanks a lot. I would, and do recommend etrailer and the back up camera kit.

im very pleased with the product (camera & rear view mirror) takes a little work to get the cables run through your vehicle (f150) and finding a good power source (my problem) had one issue with a cable mfg took care of it over all had it installed for 1 year very happy got it manly for conecting to our travel trailer but use it all the time now

One of our Technicians has about 20 years in truck aftermarket setup and thought that this rear view camera was as good as it gets. In all, the quality, installation flexibility, video quality and adjustments made this product something that we will purchase again. The compass and temperature were a bonus as well as remote control adjustments for grid lines , brightness and such. This shipped very quickly and all components are well labeled and packed. The directions are easy to follow. Our installation is mounted below a safety warning LED light so it is protected but something etrailer might think about is a surround escutcheon type thing for added protection.

Great choice. Works very well. My truck lacked 3 things that I had gotten used to having - compass, outdoor air temp gauge. and rear view camera. This solved them all! Takes some trial/error to get temp probe in right spot.

Has worked every time transmission put in reverse, picture clear and accurate to proximity. Unsure if it was a problem with the onstar section of the mirror, one time lost signal on a trip, but later worked flawlessly. Defiantly will keep you out of trouble when backing up.

I bought this because my daughter and I had both backed the truck into the camper parked in the driveway. So far, it has worked for its purpose. It does not work as well as the factory setup in my Ford Escape. The main problem is seeing the image in the rear view mirror when the sun is bright. I also need to put on my reading glasses to see the image clearly (if I could drive with the seat back another 3 inches I would be fine). The auto-dim feature of the mirror works great. After the initial install, I moved the camera from over top of the license plate to the bottom of the bumper beside of the hitch receiver, having cut a notch in some of the plastic trim so it would not block the view. That was a huge improvement. When installing on a mid 2000s Ford Superduty, there are some good videos online for removal of the A-pillar trim and grab handle. There is a wire under the dash related to PTO functionality that provides power only when the key is switched on that you can use to power the unit. Run the cable to the camera under the sill plates (these are in the bottom of the door opening) to the back of the cab before exiting to the underside of the truck. Coil the excess wire here and zip tie it. When having major engine work done, point this wire out to the mechanic in case he has to lift the cab to do the work -- there will be enough extra wire to allow him to do this without disconnecting anything.

auto dimming backup mirror works great. had a local shop install it---I'll never be without a backup camera in any car I own

Image only covers 1/2 the mirror & is too small to see any details

Hard to see in bright sun other than that easy to install

This style of camera in the mirror solves a lot of location problems on the dash. A good engineered product that should outlast the vehicle its installed on. I had good service from Etrailerr and the item was delivered intact and promptly.

Great unit. My only recamindashion would be to watch the instal video and get everthing needed to install in one ordre.

The quality of the parts seem good but the directions to install everything were horrible (essentially none existent) and I had to go to [online] to figure out how to remove my factory mirror for the new mirror install and the wiring I figured out by trial and error. The camera kit should have included longer screws to replace the stock screws on the F250 brake light. The order was delayed about a month due to supply chain shortages. Once I got got it all together it works well, just disappointed in the instructions and should have provided replacement screws.

The directions are poor at best. You have to figure it out on your own, which isn't a real big problem, but some additional information would be nice. The bezel for the camera is nice, but doesn't fit 100%. Its close enough, but you have to play with it a little. Additionally, I'm not sure why the camera has a 6' cable, then there is a REQUIRED 24' cable to then connect to another 6' cable to the mirror. I'm wanting to install the mirror in my truck, not the truck in front of me. I don't need 36' of cable, its a Crew Cab, not a buss. So it means you have ALOT of cable to stash. Also, other than changing the brightness, I have no idea what the POWER button on the mirror does. I wired to a switched power source figuring I could just press the power button to turn the monitor on and off. Guess what.. you can't. It is ON. To have this work right, you'd have to figure out a way to wire it to the reverse light switch. And once you find this issue (despite the item description clearly stating the power button can be used to turn it on and off), good luck getting help from etrailer. Was told I would be contacted by someone from technical support days ago... its been crickets. It also sucks the mirror is autodiming, despite what looks like light sensors front and rear, it does not dim (only found that mentioned in the two page "manual/install guide".