Most Popular Two Balls for 2000 Chevrolet Avalanche

Still haven't towed anything with it yet but it seems very solid. I do think it will rattle some in the receiver because it is loose in my 2" receiver on my 2019 F150.

This hitch has worked out great for me over the last year. It’s very heavy duty and easy to adjust. I’ve hauled a 9,000 lb boat, long-distance on numerous occasions without issue. I also haul a landscape trailer on a daily basis weighing over 5,000lbs and haven’t had a single issue. Great hitch that was significantly cheaper than others and is very high quality. I’ve recommended it to several people and I wouldn’t hesitate to buy again. The only thing I would like to have now in a hitch is a tongue weight gauge, but it isn’t necessary.

Click to Enlarge

This is a really solid product. The craftsmanship is great and it is American made. I'll never need to purchase another hitch. The service from Etrailer was also great. The product arrived ahead of schedule.

Excellent product , we highly recommend exactly as shown and described and it is awesome.

All in all a good set up. A lot more play in the receiver than I expected. Fair amount of rattling around without a trailer attached. In all fairness I do live in a state with poor roads.

Has done what it is supposed to do. I have used the hitch to tow two boats over the last two years using both ball sizes. The only issue is the appearance. Saltwater creates rust and break down of the coating on the hitch. Was never dunked in salt has been effected being near saltwater. Hitch was washed with freshwater after each use in salt. I probably wouldn’t buy again. I have seen some other hitches that can do similar adjustments that do better near saltwater environments.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Very strong, easy to install and very secure. Yes a bit pricey, but well worth the money. I did notice there was what I thought was an unusual amount of play in the receiver. I called etrailer and Marcia was so very helpful and very concerned that I may have received the wrong product. She even called the manufacturer and found out what the changes that were made by the manufacturer which made the pictures incorrect. My hat is off to Marcia and all the folks at etrailer

Click to Enlarge

ball mount fits loosely in the receiver so that the pins that extend out from the ball mount shaft through the holes in the receiver don't extend out far enough, for my liking. This is because since the ball mount shaft has so much play, it will shift to one side. Then, the pin on the other side does not extend all the way out of the hole so that it is not flush. True, i am being paranoid. However, i imagine a case like a crash where enough force could pull the shaft out from the not fully extended pin side to release the trailer to wreak more damage. I would just feel more secure if the pins went out further through the receiver or the shaft was not so loose. Otherwise, i really like the product a lot... enough to give it four stars... :o)

Will be using to tow five different trailers with new truck. Appears well made. Should provide the flexibility to use one hitch, instead of switching between multiple drop lengths.

Bought this hitch to tow my camper with my new 1/2 ton truck. Hitch was a little hard to get adjusted, but that could be i had never done it before. After watching several videos i got it close. I dont think it's perfect, but does its job. Only made 1 trip using it, but it was a 900 mile round trip. Didn't have any problems with sway, and hitch is very quiet when turning. Overall very good purchase hopefully get to use it more in the future.

Hello The hitch works great as viewed in the enclosed pictures. If inverted it hits the bumper, of my Dodge 2500. The section that goes into the receiver is about 1/2" too short and hits the bumper. I have not tried it on my other vehicle to see if this is a problem. Kind Regards Leon D

Click to Enlarge

A VERY nice piece that will set your mind at ease. Easy to adjust height. The ONLY thing I wish is there was an option to have different sized ball combinations. I mainly use 2" and NEVER use a 2 5/16"(or whatever the larger size is) and would prefer to have a 1 7/8" on the other side.

Click to Enlarge

Sooooo....you sent me a product that was somehow put together backwards and I cannot take them apart somehow the ballhitch is stuck on the male portion backwards and defies gravity and doesn’t need a pin to stay on(becaue thier is no where to put the pin in cause it’s backwards

Click to Enlarge

Fast, helpful, prompt service on great and helpful trailering products. Thank You

Put this together in very short order and it works great! Like the fact that you can change ball sizes in a couple of seconds.

It did the trick, although it is starting to rust.

I was unable to find this item locally. Etrailer had multiple variations to select from at competitive prices. Received product in a timely manner considering the weight. I will be shopping on your site again. Thanks.

Every item I have purchased off of etrailers has been beneficial to my organization, did not hurt that I already knew what we needed but the price was right and it was delivered to our doorstep. Items we have purchased range from tri/bi and adjustable ball mounts to load locks.