Most Popular Rise - 7 Inch for 2000 Chevrolet Avalanche

Bought to pull my boat with my Yukon and needed a drop hitch to level out the trailer. I wanted to buy a quality hitch, and let me tell you the B&W does not disappoint. Well engineered. It’s it heavy but when installed it is pretty easy to adjust height and ball size. Also supporting an American company is a plus!

Click to Enlarge

It has been a great hitch I've had no problems whatsoever and I love the fact that it's so easy to change between the three ball sizes I would absolutely order this hitch again you can't go wrong with B&W

All in all a good set up. A lot more play in the receiver than I expected. Fair amount of rattling around without a trailer attached. In all fairness I do live in a state with poor roads.

Has done what it is supposed to do. I have used the hitch to tow two boats over the last two years using both ball sizes. The only issue is the appearance. Saltwater creates rust and break down of the coating on the hitch. Was never dunked in salt has been effected being near saltwater. Hitch was washed with freshwater after each use in salt. I probably wouldn’t buy again. I have seen some other hitches that can do similar adjustments that do better near saltwater environments.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Very strong, easy to install and very secure. Yes a bit pricey, but well worth the money. I did notice there was what I thought was an unusual amount of play in the receiver. I called etrailer and Marcia was so very helpful and very concerned that I may have received the wrong product. She even called the manufacturer and found out what the changes that were made by the manufacturer which made the pictures incorrect. My hat is off to Marcia and all the folks at etrailer

Click to Enlarge

ball mount fits loosely in the receiver so that the pins that extend out from the ball mount shaft through the holes in the receiver don't extend out far enough, for my liking. This is because since the ball mount shaft has so much play, it will shift to one side. Then, the pin on the other side does not extend all the way out of the hole so that it is not flush. True, i am being paranoid. However, i imagine a case like a crash where enough force could pull the shaft out from the not fully extended pin side to release the trailer to wreak more damage. I would just feel more secure if the pins went out further through the receiver or the shaft was not so loose. Otherwise, i really like the product a lot... enough to give it four stars... :o)

Perfect. etrailer service is outstanding.

Great Customer service and great products