Most Popular Single-Function Adapter for 1999 Jeep Cherokee

Exactly what I needed...Top Quality

This is for a 2014 Jeep Cherokee Latitude. It took me a little extra time as my helper was a 5 ton floor jack and it supported the receiver and if only my right foot had fingers it would have helped a lot. Loading the bolts and plates into the frame was a snap, I left the fish wires on the bolts and that helped a lot and I didn't lose a bolt into the frame,you must leave the exhaust hanging to get to the rear bolt closest to the exhaust curve just before the mufflers I didn't and it was a bear to torque it. Also after I cut the opening on the bottom of the bumper and already had torqued the receiver I had to pry the bottom edge over the receiver there was no other way to get the hitch up inside not enough forward space to get it to slide up and in. Other than that it was a snap. Now for the wiring harness, went well had a bit of a time getting the connectors up to the tail lights even with all 4 screws out and a little bit of play I had to pry the plastic support away from the body to get the connectors through. That was for the 4 flat, for the power for the harness I have a rig runner 4005 from Powerwerx for all my power as I am a volunteer Fire Fighter and have all the goodies that goes with it and every thing runs fine. For the 5 flat all I had to do was find and take out the backup bulb in the tail light and test to find which wire was hot. And then it was over and done put it all back together and drive away with my trailer. Sorry no picture it looks just like the factory/dealer put it on. Ray H

My trailer has a reverse lockout that requires the back-up light signal to disable its brakes when backing up. This adapter did the trick perfectly.

Works as stated, just plug in to7 pin connection on car, and plug 4 pin to trailer. Nice feature w/ led lights to check if connection is good

Would be a good product if it were compatible with my Rivian R1T. The truck detects the draw of the indicator lights and insists on staying in trailer mode. I had to buy one without lights. I may or may not have used the compatibility feature of your website but you should be sure that it is set to not recommend this product to Rivian owners

I added it to my trailer, so when in camp I could have the running lights on without the truck.

You guys are great, professional, keep it up

I have now installed the following on my 2017 Wrangler: Brake light relay kit . Hopkins Towed vehicle Tail Light wiring kit. Blue Ox base plate. Blue Ox Patriot Portable RF Braking System. All of this has taken about 3 days of work spread out over a week or so. Overall it went well. Not too many surprises. Crawling around under a car at 71 is a bit of a strain but I'll get over it. I must say that Donna P. has been a wonderful source of great information and has stayed right on top of the process. eTrailer has been a great source for this project. I would recommend you all with no hesitation.

Works for me??. Just needed a longer one for my utility trailer since I switched vehicles. Always easy and fast to work with etrailer. Thanks again

It fits, it works. Great choice

product is exactly what was ordered, quick service and a very reasonable price. Adapter plug is just what I needed and is well made.

Super quick delivery and great CS helping me make decision. Love you guys.

Instructions were great. Easy to install. No problems so far

Works, exact fit, high quality, coils tight so max of about 3.5’ perfect! Heavy duty wiring, great waterproof connections.

Well made, only used a few times so far and it works great.

It's not the right connector. Different pin configuration on this porsche See photo attached

Got this for my 1980 Austrian Pinzgauer 710 that has the 7 pin EU style plug and a 24v system. I’ve got several US trailers with LED lights that work perfectly with this plug. The LEDs seem to handle the 24 volts ok saving me the hassle of having to relamp incandescent lights. This has been far easier than building a plug from scratch, I would however like to have a seven pin EU to pin US for my heavier trailers with brakes. I’ll probably end up building one but for my light towing this is a great solution.

Should come with the 7-pin mount for the vehicle. Hence the 4-star review. Part is well designed and fairly easy to install.

Perfect fit for my Tiffin motorhome, will use the flat plug for tow dolly lights.

Exactly what I ordered. Tried ordering it from Northern tools did not stock it. At etrailer no problem shipped out right away,

Provided a complex wiring adapter at a reasonable price - Thanks

Exactly what I needed to tidy up my mast wires on my sailboat.