Recommended Sealant And Butyl Tape For Installing Jensen marine Speakers On An RV
Published 04/26/2024
Products Featured in This Question
Question:
What is the correct way to install the Jensen MSX60RVR speakers on the side of a Rv like what caulking or butyl tape to use. No install instructions included
asked by: Robert M
Helpful Expert Reply:
Hello Robert. For that I suggest using butyl tape and non-sag sealant. For butyl tape I recommend the Alpha Systems Butyl Tape for RV Weatherproofing # AL28FJ. This is a 20' long roll of 1" thick tape.
For sealant I recommend the Alpha Systems 1010 Non-Sag Sealant for RVs # AL53KV. This is a single 10.3 oz tube non sag sealant and it is black in color. So, it will go perfectly with the Jensen # MSX60RVR marine speakers you were looking at.
I have linked our video for these speakers below. They briefly go over installation starting at like the 2:20 mark. They do not show how to seal and weatherproof anything though, but that part will be pretty straightforward.
Product Page this Question was Asked From
Jensen Marine Speaker - Recessed Mount - 7-1/8" Diameter - 75 Watts - Gray - Qty 1
- Marine Speakers
- Single Speaker
- Recessed Mount
- 75 Watts
- 7-1/8 Inch Diameter
- Gray
- Jensen
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Kenda Karrier ST205/75R14 Radial Trailer Tire with 14" Black Mod Wheel - 5 on 4-1/2 - LR C
- Q&A: Are The Jensen Marine Speakers A Direct Replacement For The Speakers In A 2018 Heartland RV Mallard
- Q&A: How To Determine The Correct Size Exterior RV Speakers For Your Trailer
- Q&A: How to Wire Lippert Smart Electric Jack to 7-Way
- Q&A: Will The Advent Air Heat Strip Work When Replacing A Dometic Roof Top Unit With An Advent Air Unit
- Q&A: Advent Air Replacement RV Air Conditioner for Dometic Setup
- Q&A: Recommended Marine Grade Speakers With A 6-3/8" Mounting Hole Spacing
- Article: Stability Control for Heavy Duty Vehicles