Is A Regulator Needed For A Trailer's Propane System If There's Already One On The Stove

Updated 06/26/2024 | Published 05/21/2023

Products Featured in This Question

Furrion Propane RV Cooktop - 3 Burners - 24-7/16" Wide - Stainless Steel

(53)

$290.44

MB Sturgis Vertical 2-Stage Propane Regulator - 11" Water Column Outlet

(60)

$66.34

MB Sturgis Horizontal 2-Stage Propane Regulator - 11" Water Column Outlet

(151)

$57.06

JR Products Compact Automatic Changeover 2-Stage Propane Regulator

(181)

$83.60

Question:

I purchased this SUBURBAN SCNB1BBXEX three burner slide in cooktop from eBay. It has a small regulator on it that says burner systems 1/2 PSI Maxinch and I am wanting to hook this up to a standard size 20 lb propane tank. Do I need a pressure regulator on that propane tank, if so what pressure am I looking for? Im asking this question because I am replacing the oven/cooktop that is in my trailer now so I can get away from pilot lights and Im doing a little bit of remodeling in my trailer

asked by: Mouse

Expert Reply:

Yes, you would still need to have a regulator for your trailer's propane system. All RV ovens/stoves typically have a regulator built into them to ensure that the pressure is correct for the appliance. The Furrion RV Cooktop # FGH4ZSASS you were looking at for example, has a one built in as well (pictured below). 1/2 psi is about 11-13" water column, which is pretty standard for the regulator connected to your trailer's propane system. Typically the rest of the appliances that run off of propane will be fine with just the regulator installed on the trailer's propane system.

If you don't have a regulator currently then you'll want to choose one based on the amount of tanks you're going to use and the way that the piping will be ran. If you're going to use multiple tanks then a regulator like part # 37207-31525 would allow you to easily connect to two tanks and switch between them when one empties out.

Depending on how you run your piping and where you want to place your regulator will determine which style regulator you'd need for a single tank. The key is to ensure that the vents on the regulator face down so water and debris won't get into them. If you plan on placing your regulator in a vertical position then you'll want part # 108220, and for a horizontal position part # 108221.

If you have any other questions please feel free to submit another question via our expert link and I'd be happy help you out!

expert reply by: Kevin C

FGH4ZSASS Propane Regulator
(click to enlarge)

Suburban Range Regulator
(click to enlarge)

Jim S.

6/25/2024

Can a propane regulator for a small camping trailer be installed inside the trailer while the small 20lb propane tank is outside?

Jesse M.

6/26/2024

@JimS Regulators have to vent out so you would not want to install the regulator inside of your trailer as it could potentially vent LP gas into the trailer, which can make you sick or cause death. In trailers where the regulator is in a compartment bay (usually 5th wheels) they build vents into the compartment to allow the gas to escape. It's better to have the regulator as close to the propane tank as possible so that you don't have an unregulated line that could potentially leak or get damaged.