Replacement Lift Support for LT08-05B 13-3/4" Strut on Toolbox

Question

Question:

I am looking for a LT08-05B STRUT for a tool box It is 13.75 inches ~35mm from ball end center to center.

asked by: Bill

0

Expert Reply:

To replace your LT08-05B strut I recommend checking out the Universal Lift Support # ATL43BR which installs on a 10 mm ball socket like part # UWSBALLSTUD, has 60 to 70 lb force, and measures 13-7/8" extended.

Attached is a review video for you to check out.

expert reply by: Jon G

0

Answer 1

We currently do not carry the LT08-05B strut for the US General Tool box but you may be able to use Replacement Lift Cylinder, Item #UWSLIFTCYLIND to replace the strut on your tool box. This strut is 10" from the ball socket center to ball…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The 1" Long Black Torx Wall Liner Screw #WLS100 is the best option for the plywood installation. These screws are fine thread and made for metal studs. They have a tapping edge but often a starter or pilot hole should be drilled. You can then…

view full answer...

Answer 4

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

We have everything you need to pull your new GMC Terrain or Chevy Equinox behind your RV with all 4 wheels on the ground. To do this you will need a base plate kit, a tow bar, safety cables, a lighting solution, and a supplemental braking system.…

view full answer...

Answer 7

For the 2016 Chevy Equinox the correct 4-way harness is the part #118264 or Curt part #C56210. These will attach to the factory trailer wiring port in the rear of the vehicle. I attached pictures that show you where to find the port at the rear of…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Replacement Lift Support for LT08-05B 13-3/4" Strut on Toolbox

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching