Can T10 LED Light Replace 194 Bulb

Question

Question:

Can regular incandescent 194 marker light bulbs be replaced with T10 led bulbs on a camper without any modifications?

asked by: Shawn

0

Expert Reply:

Yes, the T10 style of LED light can replace a 194 style bulb. We carry LED 194 bulbs though as part # DI68VR. I've linked the page to all your options.

expert reply by: Jameson C

0

Answer 1

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 2

The globrite 122 in red or yellow/amber are 3.75 inches by 1.70 inches from what I can find online. We do not have a direct replacement, however the closest dimension we have to replace them is 3-1/2 by 1 inch. I recommend the #MC68RB and #MC68AB. If…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 7

The OL or Overload error code is displayed when the brake circuit is drawing too much current, possibly caused by a short on the brake wire or a poor ground connection at the brake magnets. Your situation is a bit confusing so the best recommendation…

view full answer...

Answer 8

An OL error code would indicate an overload error. The cause of this is most likely a bad ground or a short to the blue brake out put wire. The first thing I would check is the connector on the back of your vehicle. Any dirt or corrosion can be…

view full answer...

Answer 9

It is usually possible to replace the spring bars in a weight distribution hitch setup so long as the two sets of bars are the same type, both trunnion style for instance, and both are from the same generation of hitch. A 10-year-old setup may not be…

view full answer...

Answer 10

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

view full answer...

Answer 11

The 18" T8 LED Light Bulb #DI73VR is going to be the correct light for your 2007 Winnebago Journey 36 with your current tubes measuring 17-1/2". The pins on the light tubes are only for securing the bulb in the fixture. They will not send…

view full answer...

Answer 12

The part you need for your Furrion RV Cooktop - Propane - Triple Burner - Stainless Steel, part #FGH4ZSASS, is the Replacement Gas Inlet Connector and LP Regulator Inlet Assembly for Furrion RV Cooktop, part #FR97PR. I have included a product…

view full answer...

Can T10 LED Light Replace 194 Bulb

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching