Hook Size of Rack'em Motorcycle Helmut Rack
Updated 07/03/2017 | Published 06/30/2017 >
Question:
I need clarification on the measurements. Your diagram shows the hook 2 inches from the main part measured from the tip yet your description accompanying the diagram refer to it a a 2 inch hook. So is the length of the hook AND the distance of the tip to the main body both 2 inches? My trailer has the ability to put a hook over the top but the outer skin is less than 2 inches from the inner wall as most trailers would be.
asked by: John L
Expert Reply:
I just went out and re-measured the hook of the Rack'em Motorcycle Helmut Rack # RA-22.
The inside length of the hook is 1-1/2 inches and it reaches about 1-1/4 inches from the main upright. It's also about 1-1/4 inches from the top of the upright to the bottom of the opening of the hook on the inside.

Product Page this Question was Asked From
Rack'Em Motorcycle Helmet Rack for Enclosed Trailers
- Trailer Cargo Organizers
- Hooks and Hangers
- Helmet Hanger
- Recreation
- Pre-Drilled Holes
- RackEm
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Towing Capacity and Weight Distribution for 2017 Jeep Wrangler
- Q&A: What All Do I Need To Flat Tow A 2023 Ford Maverick?
- Q&A: 4-Pole Trailer Wiring Harness for 2017 Toyota Tacoma
- Article: Trailer Wiring Diagrams
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: When Using Bearing Buddy Bearing Protectors Do I Need To Repack Bearings Periodically?
- Q&A: What is the Wizard Button for on the Progressive Dynamics RV Power Control Center
- Q&A: How To Find The Correct Replacement Keys For An Enclosed Trailer Access Door
- Q&A: Can the Brophy Swiveling D-Ring Tie Downs Be Used To Secure a 5,000 Lb Vehicle with Backing Plate
- Article: Determining Trailer Tongue Weight