Recommended Trimmer Rack for Open Utility Trailer with Round Top Rail

Question

Question:

I have an open trailer but the top rail is round 2.5 to 3 inch tubing . Can you please tell me which trimmer rack will work with my trailer?

asked by: Chris C

0

Expert Reply:

All of our Trimmer Racks are bolt mounted, so you will have to custom mount them on a round top rail. You will either have to run bolts through your tube or run U-Bolts around your top tube.

For a Trimmer Rack, I recommend the Pack'Em Rack # PK-6-OP1. This holds 3 trimmers, 1 blower, 1 line spool, and one cooler. It is a very nice system with a gray powder coat finish. This does not come with mounting hardware, but does come with keyed alike locks.

If you are looking for a more basic rack, I suggest the Rackem Lockable Trimmer Rack, # RA-6RL. This is a very strong and durable system. that requires 2 locks. This system does not come with mounting hardware.

expert reply by: Jason S

0

Answer 1

A side mounted jack that you could pivot up and out of the way for better ground clearance would work just fine. The A-frame location is convenient but in a situation like yours you certainly could go with the side mounted style. For that something…

view full answer...

Answer 2

I went to our warehouse and was able to locate an a-frame jack that measured less than 12 inches from the bracket up. The Bulldog Round A-Frame Jack, #BD155032, comes in just under 11-1/2 inches which included the handle. I have attached a picture to…

view full answer...

Answer 3

I went out to my warehouse a pulled a few different jacks that I think will work for you. The Bulldog Round, A-Frame Jack, #BD1550101344, measures 14-1/2 inches from the bracket to the top of the jack, but you will lose an inch of lift with a 13 inch…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Yes, the Dexter Self-Contained Hydraulic Jack #DX72CR does come with a manual hand pump that can be used as a backup in the event of hydraulic malfunction.

view full answer...

Recommended Trimmer Rack for Open Utility Trailer with Round Top Rail

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching