Adapter to Reduce 1/4 Inch Brake Line to 3/16 Inch
Updated 12/28/2015 | Published 12/26/2015
Products Featured in This Question
Question:
i am considering running 1/4 inch line from your hydrastar brake actuator after buying and installing the hydratar 1/4 line output port adapter you sell for this unit then taking the 1/4inch line to my axles where I plan to split and reduce to the 3/16inch line. Will this adapter allow me to install it into a 3/16inch inverted flare tee and then my 1/4inch inverted flare line into the the adapter?
asked by: Joe B
Expert Reply:
Adapter # T4871700 will allow you to use a 1/4 inch brake line and connect it to a 3/16 inch fitting. It is similar to # HS43-9035 in that you would thread in the brake lines.
Product Page this Question was Asked From
Replacement Adapter Fitting for Dexter Hydraulic Brake Kits - 1/4" to 3/16"
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- Brake Lines
- Brake Line Fitting
- Brake Line Components
- Dexter
more information >
Continue Researching
- Shop: Brake Controller
- Video: Review of the Replacement Step-Down Adapter for Hydrastar Hydraulic Brake Line Kits
- Shop: Replacement Adapter Fitting for Dexter Hydraulic Brake Kits - 1/4" to 3/16"
- Shop: Replacement Step-Down Adapter for Hydrastar Hydraulic Brake Line Kits - 3/16" to 1/4"
- Q&A: Replacement Coupler that Could Fit 2006 Easy Loader Trailer Sk20
- Q&A: Replacement Rims for 2020 P.J. Gooseneck Trailer
- Q&A: New Brake Assemblies, Hub/Drums, Brake Lines, and Bearing Buddy for Trailer with 3,500 lb Axle
- Q&A: What is the Correct Hub Replacement for Dexter 8-208?
- Q&A: Availability of a Hydraulic Brake Hose to Install on a Folding Trailer Tongue
- Q&A: Replacement Master Cylinder for Older Model Titan Model 60 Brake Actuator
- Q&A: Torque for Lug Nuts of Taskmaster Steel Dual Trailer Wheel # AM20783