Fitting Size of the Camco RV Water Pump Winterization Kit # CAM36543
Question:
Can you confirm size of connector? Is it 3/8 or 1/2 ??
asked by: Richard W
0
Expert Reply:
I went out into our warehouse and measured the fittings of the part # CAM36543 that you referenced and found that the inner diameter of the T-fitting is right at 1/2 inch whereas the outer diameter of the fitting is 3/4 of an inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Camco RV Water Pump Winterization Kit - Permanent
- RV Fresh Water
- Pumps
- Winterization
- Water Pump Kit
- Camco
more information >
Continue Researching
- Shop: Camco RV Water Pump Winterization Kit - Permanent
- Shop: 3-Way RV Water Heater Bypass Valve - 1/2" MPT x 1/2" MPT x 1/2" MPT
- Q&A: Parts Needed For Installing Water Heater Bypass Valve On PEX Tubing In A Camper
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: How to Use an A/C Powered Air Compressor on a 7-Way Trailer Connector
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Q&A: Difference Between 1 Diode and 3 Diode Red 2" x 4" Clearance Lights
- Q&A: Dimensions of Atwood RV Water Heater AT94022
- Q&A: Replacement Slide Out Motor for Power Gear Motor Model 13-1086
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: Recommended SnapPads For A Lippert Ground Control 3.0 Leveling System
- Article: How Does an RV Water Pump Work?
- Article: Don't Break Your Pipes or Your Wallet: Winterize and De-Winterize Your RV
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)