Search: Trailer Wheel Chock   >   Trailer Jack   >  

I went out to our warehouse to take a look at the Curt 2" Hitch Ball #C40004 that you referenced and I measured a height of 2-3/4" from the mounting base to the top of the ball. I have attached an image to assist. If this doesn't…

The part numbers for the replacement bearings and seals are as follows: Inner bearing, part #L68149 Outer bearing, part #LM67048 Seals, part #58846 I have included product description links below.

The Lippert shock kit #LC281281 will fit the 3 inch diameter round axles on your vintage trailer. The maximum extended length of the shocks is 13-1/2 inches and the minimum length is 6-5/8 inches. Basically, you will compress the shock all the way…

If you are just looking to tow a trailer with lights and without brakes, I recommend the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part #C56349. This will give you a 4-Pole flat on the back of the Tacoma to tow a…

We have three options for your 2016 Toyota Tacoma, but none of them are a permanent mount or have the extra electric components. All three are very functional and easy to install/remove when not in use. Towing mirrors like you are referring to for…

We have 7-way jacketed wiring with the Deka Wiring part #DW04914-1 sold by the foot which you could use to run all new 7-way wiring but you'd have to run individual wires to each circuit/light which a lot of people use a junction box like the…

There are common lug nut sizes found on trailers: 7/16, 1/2, 9/16, and 5/8 but the most common is 1/2 inch. If you can tell me the trailer weight capacity and wheel size/bolt pattern I can verify if they are likely to be 1/2 inch or another size. If…

The Equal-i-zer weight distribution systems aren't RV specific. The correct system for your needs will depend on the fully loaded and ready to tow tongue weight of your Travel Trailer (which will include the weight of any cargo stowed in the tow…

Trailer wheel lug nuts that are 1/2-inch inside diameter typically have a 20-TPI thread pitch (20 threads per inch). Most lug nuts also use a 60-degree-coned profile like #CE11051, but a 90-degree like #STN569 is also available for 9/16-inch studs.…

The trailer wiring harness you would need based on what you were able to find is the Tekonsha kit part #118781 which I attached an install video for on a 2018 Honda Odyssey just like yours.

Since the Fastway ONEstep Wheel Chocks #FA84-00-4840 that you referenced sit on the ground you would want to measure on the ground the distance between your trailer tires. If that distance is between 16 and 24 inches these chocks would fit and work…

That's a really good question, and while it may be technically possible to use the Fastway ONEstep Wheel Chocks for Tandem-Axle Trailers and RVs #FA84-00-4840 with blocks like the Ultra-Fab Leveling Blocks #UF48-979051, the issue is going to be…