How Much of the Draw-Tite Class III Hitch Will Be Visible on 2010 Toyota Tacoma Once Installed
Question:
will the hitch hang low so you can see it . or will it fit close up to the bumper . and is there any modifications
asked by: Dominick
0
Expert Reply:
When installed, the crossbar of the Draw-Tite Class III Hitch, part # 75236 is pretty well concealed behind the fascia under the rear bumper. The top of the receiver will be just below the fascia once the hitch is in place. The installation of this hitch will require no modifications or drilling.
For your convenience, I will include a link to the installation instructions below.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 5500 lbs WD GTW
- 2 Inch Hitch
- 550 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is the Towing Capacity of 2013 Toyota Tacoma TRD and Hitch Recommendation
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Difference Between Curt & etrailer Trailer Hitches For 2024 Subaru Crosstrek Wilderness
- Q&A: Comparing Draw Tite and Curt Hitch for 2006 Toyota Tacoma
- Q&A: Adding 7-Way Trailer Connector to 2014 Toyota Tacoma without Factory Tow Package
- Q&A: 2009 Toyota Tacoma Hitch Installation Question
- Q&A: Differences Between Curt, Draw-Tite, and etrailer.com Trailer Hitches for 2019 Subaru Outback Wagon
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Ball Mount Basics: Weight Capacity, Class, and Size