2019 GMC Sierra 2500 Wheel Well Guards

The Gen-Y Weld-On 2" Receiver Tube #325-GH-003 is 2-7/8" wide on the tube and 3-1/2" wide at the collar. The overall length is 12".

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package part #BWRVK3775 weighs 250 lbs but it's easily broken down into two parts consisting of the head which weighs 70 lbs and the base which weighs 180 lbs.…

The head portion of the Reese 18K Select Plus Fifth Wheel Hitch is height adjustable from 14 to 18 inches above the floor of the truck bed. To raise the head, remove the bolts that attach it to the support legs of the hitch, and reattach using the…

Your Curt Pop-In Ball for Factory Ford and Ram Underbed Gooseneck Hitches - 2-5/16" Diameter Ball #C60601 lifts the pin when that lever is lifted. Because that lever is broken off you will need to lift that pin and turn it 90 degrees to release…

I'd be happy to assist you. It sounds like you need the Sealed, Flush Mount Tall Rectangle LED Trailer Stop, Turn and Tail Light, Grommet and Plug, 12 Diode #STL34RB but most of the pictures I see have round tail lights like the Sealed, 4"…

I have a great suspension system for your 2022 GMC Sierra 2500. I recommend the Air Lift LoadLifter 7500 XL Air Helper Springs item #AL57541. They have a 7,500-lb Capacity and are the only air bags compatible with 5th wheel hitches. The 7"…

The programmer I recommend for your 2018 GMC Sierra 1500 is the Edge Evolution CTS3 part #EP49YR because it can give you up to 18 additional horsepower and 27 ft lbs of torque. It also has the ability to give you several gauges on the 5-inch display…

The recommended minimum clearance between gooseneck trailer overhang and truck bed rails is 4-6 inches. I'd recommend 6 inches but a lot of people get by with just 4. Ideally you have at least 6 inches of clearance and the trailer is sitting…

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

DOT5 brake fluid is what you'd want to use in the Dexter surge actuator part #DX89FR. If the breakaway pin was pulled it would be replaceable. The breakaway cable is replaceable.

To replace your TDE Model LP7000 actuator, I recommend the Dexter DX7.5L A-60 Brake Actuator w Electric Lockout item #DX89FR. This coupler is designed to mount on top of a standard 3" wide trailer tongue. It measures right at 3-3/8" wide so…

Though I do tend to warn people about the ride getting stiffer when upping the capacity of their leaf springs, you are correct in that you will technically never be fully "unloaded". I do have to mention that this could still happen, but…