We don't have the 2910SB listed as we haven't obtained the information about it from the manufacturer. If the sticker on your Rockwood 2910SB Ultra Lite lists a 4400 lbg axle then I'd be inclined to trust that information, but you can…
The difference between Blue Ox SwayPro heads #BXW4011 and #BXW4012 is the angle at which the trunnions are relative to the head. Head #BXW4012 is designed for underslung, also called bottom-mount, couplers so the bars are not at as a steep of an…
Great question, Ludwig! The RV Propane Gas and Carbon Monoxide Detector #RS34FR can be placed closer to the floor because LP is heavier than air, and while CO is technically lighter than air, it disperses evenly in a room as opposed to pooling at the…
We do have the exact bearings, races, and grease seal you need for your 4,400 lb Dexter axle, and while there isn't a single kit with the parts, you can get them all individually. What you will need are the following: Bearings #L68149 and…
Hey Kenny, so for the arm itself you can use the Replacement Short Arm Assembly for RV Awnings #LC404523 and for the cover you can use either #LC643922 (drive) or #LC643923 (idler) depending on which side you need.
I have to agree with you that it sounds like something is wrong with your Lippert powered tongue jack since the courtesy light should go off completely when the switch is in the off position. I suspect that there is trapped water inside the switch…
For your Reese Sliding Fifth Wheel Hitch #RP30051 we offer both a replacement head unit only, part #RP58146, or the head and crossmember assembly #RP30047A. You can choose the one that includes the mix of components you need. For the sliding legs you…
All you're going to need to do is take note of the shape, the amount of jacks you have and measure the size of your jack feet. For instance, if you had 4 6" square feet then you could use the SnapPad XTRA Square 6 Jack Pads for Lippert…
The MORryde RV Cargo Sliding Tray #MR47FR has 1.57" of clearance from the bottom of the tray to the bottom of the slides. More than likely you will need the Height Adjustment Kit #MR34VR which will raise the tray to sit 2-1/2", 2-3/4",…
If the door on the oven part of your Furrion 2-in-1 Range Oven with Glass Cover #FR37KR doesn't close all of the way then that is a problem and definitely the reason why it took an hour to pre-heat. If it looks to just be the construction of the…
