As long as the seal in the bearing kit part #BK1-150 is flush with the hub it is okay to have a small gap between the seal and inner bearing. When installing the seal you only insert it enough so that it is flush with the hub. The seal's job is…
Item #QR94FR has a TPO Coating and won't require a UV roof coating but will not accept any paint colors so you would be stuck with the white color of this tape. Item #QR77FR is about .20mm thicker and made with a paintable coating on it so you…
Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…
While I do not have any way to look up the parts used in the construction of your 2004 Weekend Warrior Super Lite FS 2300 I do see it has a GVWR of just over 7,000lbs which means you likely have 3,500lb leaf springs under your trailer. You will need…
I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65 ft/lbs…
Hey Robin, the Atwood 93756 that you mentioned has been discontinued for a while but we've spoken with Atwood and they said that the #AT96117 is the most similar gas and electric water heater to replace what you have. This is the same dimensions…
The best replacement for your CS-6000XL is the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4560K18LS8. This has the same 60 amp output and fits a 13-1/4" tall x 10-1/8" long rear cutout. It…
The Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger #PD4560K18LS8 that you reference will work fine as a replacement for your American/Centurion CS6000 Converter. Since there isn't any direct replacements…
I went out to the warehouse and measured the distance from where the hitch side plate will attach to the web of your motorhome I-Beam, and I got 1-1/4 inches on center. I attached a photo showing the measurement from the outside of the plate to the…
