Custom Fit 2014 Nissan Armada Accessories

The picture you have provided looks like the 2014 Nissan Armada 2-wheel drive model that you have does have a bump stop and Timbren does not exclude 2-wheel drive models so you will be able to use Timbren springs #TNRARM. I have linked a help…

Thanks for the picture! The Optronics Flexible LED Light Strip item #UCL90CB is extremely versatile. It will connect to any 12-volt power source so I am sure whatever power source and switch your lights are currently running off of will work with…

Because your trailer is fairly heavy, I would recommend you go with 2 of the #58392 lift brackets. The 58392 has extra gusseting welded to it for reinforcement, and would be better suited to a heavier trailer like yours, because the spring bars…

Yes, the Optronics Flexible LED Light Strip #UCL90CB does have wiring on both ends allowing you to cut the strip in 2. We also have the Optronics LED Light Strip 12-Volt Connector with Wire Leads #A90PB if you need to cut it into additional pieces.

Yes, the Optronics Flexible LED Light Strip part #UCL90CB can be cut to the desired length you need for your application. That said, there are cut lines on the strip you must use which are located every 2". Once the cut is made you can then…

The hitch ball angle adjustment on weight distribution systems is designed to provide more or less distribution of the tongue weight on your trailer hitch to the trailer and vehicle axles. If you adjust the ball angle farther away from the towing…

Since your loaded tongue weight is only 740 lbs you want to go with the 1,200 lb bar, part #RP66009, as this gives you a tongue weight range of 600 lbs - 1,200 lbs which is more than enough for your towing setup. If you went with the 1,500 lb bar…

The Firestone Coil-Rite Air Helper Springs #F4150 will work with the OEM air suspension on your 2017 Nissan Armada as long as the air bags aren't installed inside the coil springs (see attached photo). I tried looking up where the air…

It looks like the set screw on your weight distribution system is bent along with the part of the snap-up bracket it goes through. This is normally an indication that the system was overloaded, the trailer requires a higher capacity system, or the…

On a weight distribution system that has spring bars hanging from chains, once you engage the spring bars and lower the jack the chains will be tight. It does sound like some adjustments need to be made though since you should have about 5 chain…

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I…

How many links get used when installing a weight distribution system really depends on the tongue weight of the trailer. Basically you set up a WD system so that the tow vehicle sits as level as possible when loaded. Changing the amount of links…