Valterra RV Blow Out Plug for Winterizing Spec Review Video

Thermaheat does not have a specific recommendation on how many heating pads to use like with the #277-000161 that you referenced. You'd have to use your best judgment based on the climate and setup of the pipes on your RV. This was mainly…

There's nothing stopping you from using a Holding Tank Heater Pad such as #277-000164 on black or gray water tanks. However with the black water tank adding a heat source could create excess gases which could be a potential problem.

When this has come up before, ThermaHeat recommends removing a portion (18-1/4 x 12 in this instance) of the insulation on the tank large enough to install the #277-000164 heater so it's in direct contact with the tank. You're correct,…

The Kat's Heaters Handi-Heat Magnetic Heater #KH1155 was specifically designed to heat up various fluids in the engine of your vehicle. Since it has a heat output of 300 F - 400 F I recommend going another route. A better way to go is with the…

The Therma Heat heating pad #277-000164 is thermostat-controlled, automatically turning on at 45 degrees Fahrenheit and turning off at 67 degrees Fahrenheit. I do not recommend applying insulation over the heating pad as this could retain enough heat…

We've had this question before and the manufacturer of the ThermaHeat #277-000164 that you referenced has stated that it's okay to insulate over the heating pad.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

Hello Joe, Thank you for reaching out! The Power Mountain Tallboy Off-Road Bottle Jack - 11-5/16" to 27-1/16" Lift - 12 Tons #PM94FR does have the capacity you’d need, but since your fifth wheel’s frame sits about 25" off the ground,…