Comprehensive Review: Wire Loom, 1/2" Diameter (per Foot) Video

If you wanted to make your 12 volt power circuit turn off when the vehicle is turned off you could install the isolation solenoid part #PK5231201 on the circuit. You'd need install the circuit to the outside posts and then for the center pin…

The 12V wire at the vehicle-end trailer connector being hot even when the truck is off can vary depending on the application. For all aftermarket hardwiring installations of a 7-Way wiring harness, the 12V wire will be hot at all times, even when the…

The color of the light that the Low Profile LED Flood Light part #OPT64FR puts out is a bluish white which is very common for LEDs. For a warmer light that would work great the Omega LED RV Porch Light part #328-007-30SCPE which puts out a warmer…

If you need some additional wire loom to clean up your recent installation of the Roadmaster Battery Charge Line Kit #RM-156-75, I recommend using the Wire Loom #7509-1. This 1/4 inch diameter, split wire loom is sold by the foot so you can order the…

Rewiring your 14 foot dump trailer is pretty straight forward. I would start with a 20 ft. Wishbone 4-Way Trailer Wiring Harness, #A20WB, to provide wiring for the stop turn and tail lights on your trailer. We have a video detailing how to install…

As you noted, the typically wiring colors for a 4-Way connector is white for ground, brown for tail/running, yellow for left stop/turn, and green for right stop/turn. The confusing part is that even though this is the typical way that the wiring is…

There are several reasons why the power wire has to connect directly to the vehicle battery when installing trailer wiring harness #118786 on your 2018 Jeep JL Wrangler. First, the 12 volt accessory circuit was not designed to support the additional…

If the outside width of hanger #E4139 is 2-5/16 inches and the metal thickness is 3/16 of an inch then you would take 2-5/16 and subtract 3/16, and then subtract another 3/16, to get 1-15/16 inches. It is meant to be used with leaf springs that are…

The difference between load ranges varies based on the tire size and brand. When comparing two tires of the same size and brand, a load range D tire will always have a greater weight capacity and psi rating than a load range C. However, when…

The LED Combination Trailer Tail Light part #STL14RB would be a suitable replacement for the passenger side tail light on a 2019 Bass Tracker Trail Star Trailer. If ever needed, we also have part #STL15RB for the driver side.

Yes, if you had no need for a license plate light you could use the LED Optronics trailer light part #STL14RB on either side of your trailer. It would just need to be flipped over like you mentioned so that the reflector is on the right side.

For the drivers side light to go along with the part #STL14RB that you referenced you would want the part #STL15RB. This is the matching light you are looking for.