Optronics Off Road Lights - Light Bar - UCL23CB Review

content loading

Customers compare UCL23CB to these similar products




Products Featured in this Video



Review of Optronics Off Road Lights UCL23CB


Speaker 1: Today, we're gonna take a look at the Optronics nine-inch long mix beam LED off road light bar. This LED light bar will deliver a nice bright mixed beam which is ideal for off road driving. It gives you a flood beam, which is great for seeing out in front of you and off to both sides. That would be your four lights on each end, would be your flood beam. And then your spot beam would be the four right in the middle, which is great for seeing at a distance. It is a high quality light output from the two rows of six LEDs.The LEDs do have a 200,000 hour life span.

This does use durable surface mount technology construction of the LED circuit board. That will help better withstand any shock and vibration, allows for inaudible 00:00:38 heat distribution. On the back of it if you notice, they used channeled fins on the housing, which will let the heat quickly dissipate to optimize LED performance. It is a durable, water resistant construction. It has a black powder coat di-cast aluminum housing, which is rust proof.

It uses a tough polycarbonate lens, which is impact resistant.And it is IP65 rated for protection against dust and moisture. This is compatible with 12 volt DC and 24 volt DC systems. It's a very easy installation. It has the universal mounting feet here to provide a nice sturdy base. It does include some rubber padding that you put on the feet to help prevent scratches on your mounting surface.

It has a 16 inch long, 16 gauge power leading ground wire. And then the mounting hardware and an Allen key included. It is adjustable, you just use your Allen key to tighten this up, adjust it to where you need it. A few specs on this. The light output, the effective lumen output is 1,550 lumens.

The raw lumen output is 2,520 lumens. It is 12 diodes, or LEDs.Total wattage is 72 watts. The power draw at 12.8 volts DC is 3 amps. At 24 volts is 1.5 amps. Input voltage is 12 volt or 24 volt DC. A few dimensions on this and then we're going to hook it up and show you how bright it is. The overall length, we're going to include the feet on the mounting brackets. So there's your ten and a half inches long. Total height is going to be four and three quarter inches tall. The total depth on it from this end to this end is going to be right at about three and a half inches. Now, the light bar itself, if we just measure from here to here, is going to be right at seven and a quarter inches. The height on it is three inches and the same depth would be three and a half inches. So what I'm going to do now is I'm going to take our power wire, which is the red wire and our ground, which is the black wire. I'm going to hook this up. Then we'll turn off the overhead light. Let me go ahead and turn off the overhead light.with the overhead lights off, we'll go ahead and turn on the volt power and you can see a very bright . let me shine it down because you can see how bright it is. I don't want to . and again, the four on this side and four on the ends, so eight of them will be flood, which will go off to both sides and in front of you. Then the four in the middle are straight spot beams for seeing at a distance. You can see how bright it is. I'll back it up a little bit, very bright light. And we'll go ahead and turn our power off, turn back on our overhead lights. I'm going to disconnect it, but that should do it for the review on the Optronics, nine inch long mixed beam LED Off Road light bar.


Questions and Comments about this Video

Info for this part was:

Employee Jeff D
Installed by:
Jeff D
Employee Randy B
Installed by:
Randy B
Employee Kathleen M
Video by:
Kathleen M
Employee Chris R
Video Edited:
Chris R

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.