Trunk Bike Racks Specs:
Features:
...Trunk-mounted rack lets you carry up to 3 bicycles on the back of your vehicle Arched body fits over many types of spoilers HideAway anti-sway cradles with ratcheting straps hold bikes at 3
Installation Notes: Place top clips in the gap at the front edge of the top of the trunk, hatch or door Place lower clips in the bottom edge of trunk or hatch. Caution: Rear wiper can not be used when carrier is mounted Lower arm of carrier should be positioned on upper tier of bumper.
Trunk Bike Racks Specs:
Features:
...Capacity: 3 bikes Weight capacity (total): 105 lbs Weight capacity (per bike): 35 lbs Carrier weight: 10.8 lbs Distance from center of arm to center of arm: 14" Lifetime warranty Note: This dual-...
Installation Notes:
Place top clips in the gap at the front edge of the top of the trunk, hatch or door
Place lower clips in the bottom edge of trunk or hatch.
Caution: Rear wiper can not be used when carrier is mounted
Lower arm of carrier should be positioned on upper tier of bumper.
More Information >Videos
for Trunk Bike Racks
Help Articles
for Trunk Bike Racks
Expert Answers
for Trunk Bike Racks
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...That is an excellent question and is asked more often than you think. Electric brakes like what come in the Electric Trailer Brake Kit #AKEBRK-2 can be submerged in water when you are loading/unloading your boat. Since water and electricity…
view full answer...I'm assuming your Express doesn't have the 7-way, but does have the capped round plug behind the bumper on the drivers side frame rail, you'll install part #30955. Simply remove the cap and plug the connector in. To wire up the controller…
view full answer...Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…
view full answer...Since the discontinued MaxxAir 4700k model fits a standard 14 x 14 RV vent opening, I recommend the MaxxFan Plus Roof Vent w/ 12V Fan - 10 Speed #MA00-04500K. The MaxxFan Plus comes with a thermostat and a remote for easy temperature customization.…
view full answer...The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…
view full answer...The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of 4,400 lbs. My recommendation for a…
view full answer...I checked your order notes and the leaf springs you bought last year were the part #e28SR which are for 5k axles. Since this is over the capacity of your axle failure would not have been caused by over loading the trailer assuming you stayed under…
view full answer...The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…
view full answer...Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…
view full answer...We only carry one trunk mounted bike rack that will fit your 2018 Honda Civic Hatchback. Take a look at the Saris Bones EX 2-bike Rack #SAR83FR. This 2-bike trunk rack has an arched dog leg that fits over the spoiler on most sedans, hatchbacks, and…
view full answer...