Search: 9106   >  

I attached a picture that shows how the #SL58W will install on a trailer with a ramp. I used arrows to point out the latches and the holes that it will fit into when folded up and latched. I also attached a picture that shows where you would weld the…

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

The leg length or the depth that the garnish part #2756 has is right at 2 inches. From the picture you submitted it looks like you installed the roof vent part #9106 with the mounting flange on the inside of the trailer. The vent should be installed…

The lens you are looking for is part #APL5CB which is the clear lens for the RV Porch and Utility Light #RVPL7CB.

Yes, for a white base version of the #RVPL7CB you'd want the part #RVPL7C.

The PD9140A is a converter that has the smart charger setup built into it so the correct pendent would be the part #PD92201.

The first thing I would want to know here is where you tested the voltage at on the Charge Wizard #PD92201 - if you didn't test it directly at the converter box, you'll want to start there. If the voltage at the converter is different than…

There are a couple of things to take a look at with the Progressive Dynamics Inteli-Power RV Converter and Battery Charger #PD9130 & Charge Wizard #PD92201. The most likely is either a blown fuse (or fuses) so you will want to start there. Next,…

I do have a suggestion, because we have a gas strut with with dimensions that are the same as the Stabilus 654150 which is likely to work; the Stabilus strut measures 26.46" when extended with 120 lbs of force. The nearly identical strut we…

We do have the white Replacement Exterior Half-Moon Trailer Vent for 3" Diameter Hole #WHMAV2 which is the white version of the #HMAV2 that you referenced and also is what you sent in a picture of so it would work well for you.

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

The correct replacement control module for your Kwikee Steps with Control Module 909513 is the Lippert Components Kwikee Control Unit part #LC379606.