!Liberty Travel Trailer  x   >   !Loctite  x   >   1982  x   >  

Does the RAS kit fit my 1982 c10 if I lowered the rear about 4” from stock by changing the shackles in the rear system? I was thinking this system maybe a good solution before changing the rear to an independent suspension system. | In order...

i have a super top now and looking for a super soft top with 2 piece doors in black would be nice without hardware to replace my old one and save some money can you help | Out of all of the tops available for the 1982 Jeep CJ-7, all of the ones...

Hi, Ive been trying to find the correct hitch that will mount to my 1982 2WD Toyota pickup truck. Ive looked at 3 models specifically that there was some suggestions around but I was wondering if you were able to give me a more clear answer...

I have a 1982 International Harvester dump truck with a large bench seat. The bench is 65inch wide and 18inch deep. The back is also 65inch wide and 20inch tall. Can you please tell me what will fit, and/or provide dimensions for these covers? Thank...

In Kats Catalog it say that this heater should fit numerous older vehicle, including my 1982 Ford F150 with a 5.8L V8 engine. Yet in multiple places online Amazon this heater is said not to fit. I have attached a screenshot of the PDF. | Kat's...

I have a 1982 F250 with a 38-gallon after-market rear gas tank - it hangs down below the frame rails, so any hitch that attaches to the frame rails must not encroach on this area between the frame rails in the vicinity of the tank. It looks...

Do you have a rear chrome stepbumper for a 1982 Ford F100 Flareside. They are different than a styleside. Thank you | I checked with our vendor Westin and confirmed that the only rear bumpers available for a 1982 Ford F100 are the ones listed...

Based on the picture of your 1123-1 brackets for the Roadmaster towing products, and my 1982 Toyota pickup 4WD with leaf springs, do these brackets bolt UNDERNEATH the frame in the existing holes in the frame? I have taken pictures of my truck,...

Lookinh for a seat like this for my 1982 cj7 but with seat belts. Any available? | Seat belts bolt to the vehicle and not to the seats so the Bestop TrailMax II Fixed # B3943715 would fit your 1982 Jeep CJ-7 but since you would have to run the...

will it work on a 1982 vw vanagon westfalia the converter I installed is not powered the brake and turn signal are very dim or do not work do you have a power converter kit that will work. thanks | The Hopkins Active Taillight Converter with...

Is this brake assembly submersible in water? When putting a boat into water the axel, hub, and tire all go under water... will this brake be damaged? Or is there a different brake just for boat trailers. Sorry if my question is convoluted. |...

Looking at a bike rack repair set part #Y8890179. Do you sell the straps alone. I need a full set of the 10 hole straps. Thanks. Mat | Hello, yes we have affordable replacement parts available for the Yakima FlipSide or SwingDaddy Hitch Mounted...

I have a 1982 el camino with air shocks, can I also use the AL60769 for extra support when I need it. thanks | The correct Air Lift 1000 Air Helper Springs for a 1982 Chevrolet El Camino are the # AL60733. The # AL60769 is for other vehicles...

I installed my new light kit as per video from 2007 Chevy 2500 Silverado to a 1982 CJ7. No splicing no added features, right out of the box. The problem is both lights blink at the same time from both Rand L turn signals. Brake and Night...

Trying to set up a 1982 cj7 for flat towing. I need to determine what equipment i need for a stowmaster system. base plate/wiringharness,and tow bar. can you help? | I would be happy to recommend a flat towing setup for your 1982 Jeep CJ-7. Since...

I am confused by the website choices. What I need is a trailer hitch assembly, max. 5000 lb., for a really old vehicle... a 1982 Winnebago Warrior, based on a Chevrolet G30 chassis. Im rebuilding the vehicle, and a previous owner had removed...

I want to just make sure I get the right hitch I have a 1982 chevy c10 6 foot bed step side | The etrailer hitch part # e88AR that you referenced is a confirmed fit for your 1982 C10 6 foot bed step side bed and would be a great option. |

Which tent would fit a 1982 VW Bus vanagon side entry door? | The Let's Go Aero ArcHaus Tailgate Tent that would work the best on the side door of your 1982 Volkswagen Vanagon is going to be the part # SAR024-031. This normally is used for the...

is this listing for the denim or the vinyl? im wanting the denim, but cant really differentiate between the two. | The Bestop Soft Lower Half Doors for Jeep part # B5303801 are constructed of vinyl. If you are looking for denim then you will...

I need tow mirrors for my old 1982 Ford E250 Fiesta Camper Van ..it has the stock van mirrors W/ aluminum metal,triAngilar shaped,frame w /rectangle mirror on a single mount stub Post and hole ,thru triangle frame | Since there are no custom...

If the holes are 1/2 inch diameter, how can the centers of the holes be 7/8 inch apart?? Currently working on a 1982 Toyota 4WD pickup with leaf springs. | The two round base plate mounting holes closest to the front of the vehicle are 9/16...

I have a 1982 Ram charger. After market bumper that will have to be beefed up. The installation instructions are pretty specific on measurements. How critical is it that I maintain the 21 1/8inch distance between the base plate inner bolt holes....

Will this cover fit over my existing bikini top? | The Pavement Ends # PE4172709 canopy cover would indeed fit over an existing bikini top. I've confirmed this with my Pavement Ends representative. The # PE4172709 is a fit for your 1982 CJ-7. |

So I am trying to wire up my trailer that has a 4 wire plug and the brake lights and turn signals are on the same circuit. I have tried two Hopkins converters both to no avail. One, the turn signals only work when brakes are applied and the...