Result: Brake Controller with Wiring

are not vehicle specific. I have also attached a wiring diagram of the ETBC7 kit and with a brake controller | There is no 4 way connector or anything on my truck and i want to add a 7 pin...

brake controller we need to ensure that your truck is wired correctly. If you don't already have one | I want to add a brake controller to my truck, its a 72 Chevy K10 truck, now, can you provide...

Does Tekonsha make a time delay brake controller that uses the same wiring harness plug as the P3 | Does Tekonsha make a time delay brake controller that uses the same wiring harness plug as...

will provide you with the vehicle side 7-way connector and wiring needed to install a brake controller | Will this hitch fit with a step bumper ? | Yes, the Curt Trailer Hitch Receiver # 13028...

what gauge of wires I should run for both the hot lead and the brake control wire. thanks. | I am rebuilding a 1972 chev truck. I am at the frame stage now. I want to run the...

be combined with our 7-Way Kit # ETBC7. This will allow you to install a Brake Controller # 90195 | need 6000 lb hitch for 1972 c10 chevrolet. | If your 1972 Chevrolet C10 pickup has a standard bumper you will...

with brake controller you will also need the Universal Installation Kit # ETBC7 and a Brake Controller | i have a step bumper on my 1972 k-20 so i will need 1 that will clear...

Trailer Brake Controller # 90195 can be installed with the 7-way wiring. | Hi, I have a 1972 Chevrolet K10 4WD truck. It has a 307 V8 engine w/ 3 speed on the column. It has leaf springs...

into the left turn/brake lights and the green wire is for the right turn/brake lights. I also recommend | Im looking for a t-connector wiring harness for my 1972 vw bus campmobile. | I do...

with electric brakes. My vehicle is rated with max. tongue weight of 500 lbs. and max trailer weight at 3500 | Hello ...reviewing installation instructions for receiver #13580 for a 1972 International Scout II equipped with...