!V70  x   >   !Shadow  x   >   Stackers  x   >  

Will the Lippert components stabilizer work on an 1987 Avion ? Also, does both sides need to be level ground for the two arms to work effectively? | The Lippert Components High-Speed Power Stabilizer Jack - 30" Lift # LC298707 which includes...

Got an out a stroke code. Says that they have been extended to far, but it’s on fairly level ground | If you're getting this error then you'd want to use more blocks, like part # A10-0918, so that you won't have to extend the legs of your Lippert...

Is there anything taller than this? I have my tongue jack fully extended with over 8inch of blocks under the jack and still having a hard time removing my WDH bars. | I have a solution for you, but the Valterra # A10-0900 is going to be the...

I noticed that the one video showed using the blocks under only one axel. Isn’t it bad to shift all of the weight from the two axels on to the one axel? | I believe you're talking about the video I have attached of the Stackers Leveling Blocks...

I recently bought the 6 point Lippert System for my 2005 Weekend Warrior 40 Fifth Wheel Toy Hauler. I was able to install it with some custom brackets and installing the electric motors above the floor. Now I need legs or extra blocks.... The...

Does the Malone Telos loader come with longer legs? Its supposed to be compatible with my car -Ford Expedition, but the legs fully extended dont reach the ground. It was extremely difficult- but with a major effort and 2 cases of coke to...

How much does the 4-pack weight? | The Stackers Leveling Blocks for Trailers and RVs - 1-3/8" x 8-1/8" - Qty 4 # A10-0916 weigh approximately 4 lbs or just under 1 lb each. I've attached a couple review videos of this product to assist. |

Regarding product Item # A10-0917, the description sounds like it is 4 inches tall but nothing else confirms that. are these just singles of the 8x8x1.5 or are these actually taller? Is so, what are the pad dimensions? Thank you. | The Stackers...

What is the required distance from the ground to BDC Bottom Dead Center of the axles? I want to make sure these will work? | The TrailerLegs Tire Saver Stands - Tandem Axle # 326-TRLLG-4 have overall dimensions of 15" long x 8" wide x 19"...

I was wanting to know which blocks you would recommend for a 40ft fifth I generally put one solid cement block on each leg in front and I have two solid cement blocks on each of the back, I like your extreme you sell not sure if they can hold...

I bought the stacker blocks A10-0920, for my fifth wheel. What is the max weight for each block. Im using 4 of them for leveling purposes. | Whether you are using just 1 or all 10 of the Stackers Leveling Blocks # A10-0918 the maximum capacity...

I have a 6x14 diamond cargo ta cargo trailer that i will be storing outside for months at a time. Can this product be used for this application? Also, what could be used to place under the trailer jack to keep it level? Thank you. | The TrailerLegs...

Does the Stackers come with the Chock, like the photo shows? | The Stackers Leveling Blocks w/ Bag for Trailers and RVs part # A10-0920 does not come with any wheel chocks. That said, we do offer this separately using the Wheel Chock for Stackers...

I see a similar question answered stating a linked video that I do not find. I see regular video but I need to see how it can work when there is no room for a needed 2nd set on double axle 5ers rear axle. With them being 15inch long and 4inch...

Hello, Would you happen to have any leveling blocks for Hydraulic Jacks that would support a 45 Tiffin Phaeton? The total GVW of this coach is 45,000 lbs. and there are 4 hydraulic jacks. Thank you.. | Hey Robert, we have stackable leveling...

Can LC314667 be used on Lippert High-Speed Power Stabilizer Jack? Wanting a bigger foot print on the rear stabilizing jacks. | There isn't a larger foot plate you could install on the # LC298707 that you referenced and the foot you did mention...

I have a triple axle toy hauler. Can I use the red stackers on the front and rear axles only to work or should I stack all three axles? | That's an interesting question, but leveling blocks such as # A10-0918 should be used on all three axles...

Hi, I would like to buy some Leveling blocks, but I was hoping you had a size that was a bit wider. Do you have anything wider then 8-1/4? About 12 to 16 The one I saw on your website is Item # UF48-979052. If you do have something wider...

I have a 2009 Heartland Cyclone that is without a leveling and stabilization system. I have already added the ultra fab front jacks and would like to add 4more to level and stabilize the unit. Each jack will have its own switch. do you have...

Can I raise my self leveling jacks higher then 9 inches | In regards to the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC358590, the front jacks have a 21" travel and the rear jacks have a 12-1/2" travel. If you...

I have a 22.5 ft, 3900 dry weight travel trailer and find backing it on to leveling blocks very difficult. If I use 4 leveling jacks, one for each corner, would I still need to use leveling blocks? | The # UF48-979002 feature oversized footplates...

On Part# Item # A10-0918 - what is the maximum height you can stack the leveling block | With the 10 blocks that come with the Stackers Multi-Use Wheel Supports # A10-0918 that you referenced the overall height max when using them with 4 pads...

I have a 2003 GMC Sierra 2500 HD standard bed pickup with a Four Wheel popup camper installed. I have two 17 foot long sea kayaks I would carry on the roof of the camper with the roof down . The camper has a Yakima rail system with round crossbars....

For part # A10-0916, how much lift will be given for each block. It states they are 4inch tall. So that means each block would provide 4 inches of lift? And two blocks would give 8inch of lift? If so, this is exactly what I am looking for. Thanks...