How To Determine Correct Bunk Boards and Mounting Hardware For 17' V Bottom Boat
Hi, I would like to switch my boat trailer from rollers to a bunk system. The boat is a 17ft center console with an average V hull. Hull weight 1000lbs, motor 250lbs, 29 gallon gas tank capacity. Current setup has 2 pair of rollers on 32inch...
Comparing Flex-A-Lite And Derale Transmission Coolers For A 2016 Honda Pilot
I have a 2016 Honda Pilot EXL with 6 speed tranny and am looking at your coolers. What is the best one for this vehicle? The FLX400117 is the most expensive. What do you get with that one that the others dont have, quality features? Thx. | When...
Which Bearing Buddy to Use with CE Smith Trailer Hub Assembly CE13100
Hello, I have the CE Smith Trailer Hub Assembly 2,500-lb Axles - 4 on 4 - on my boat trailer and Im wondering which bearing buddy would fit. Thanks for your time. | The CE Smith Trailer Hub Assembly # CE13100 has a hub bore diameter of 1.98-inches...
Could Trailer Fender # CE17100ATB be Used on Trailer with 13 inch Wheels
Can I use this on a trailer with 13” wheels? | Yes, the trailer fender part # CE17100ATB can be used on a trailer with 13 inch wheels. Basically we have wheel size suggestions for the fenders we carry but the best way to verify fit is to check...
How to Find Replacement Hubs for PWC Trailer
Hi - I picked up a small used trailer jet ski or 12foot boat that sat a while and needs new bearings and hubs. The brand may be Seminole. Existing bearings and hubs do not have numbers, or may not have fit right when they were put on frankly....
Bolt Hole Spacing of CE Smith Bolster Bracket # CE10052-32G
What is the space between the holes? Im trying to determine the bunk space if I use this bracket. thx | If you look at the provided photo, you can see the bolt spacing of the CE Smith # CE10052-32G bolster bracket. |
Is 20 Threads Per Inch a Fine Thread Pitch for a 1/2 inch Wheel Bolt
I believe 20 threads per inch is considered fineinch pitch versus coarse. My old lug nuts are fine pitch and just wanted to make sure I am buying the right ones. Thanks | 20 threads per inch would be a fine thread pitch on a 1/2 inch wheel bolt...
Filter Your Search
Contact and Help