Can Trailer Ball Hole in Towing Bumper Be Enlarged to Accommodate a 2-5/16 inch Trailer Ball
hello, i have a trailer that uses a 2 5/16 ball but the hole in my bumper is to small. would i be able to make it bigger safely? the hitch that is in the pic is not any good and has been cut on or i would just use it. | I wouldn't recommend...
Trailer Hitch Recommendation for a 1998 Chevy S-10 with Stepside and Roll Pan
Im looking for a trailer hitch for a 1998 s10 stepside with the roll pan bumper or non towing bumper. Its a 2.2 4 cy LS package. Im hoping you have one that doesnt require cutting to the roll pan. Please help me if possible thanks! | The Draw-Tite...
Trailer Wiring Harness Installation For a 1995 Chevrolet S-10 Pickup
I am trying to put a wiring harness on my s10, It has a wiring harness already ,but is needs the end for a trailer hookup. But Iam not sure what to order? | If you have the bare wires that are connected to the vehicle lighting circuits, but...
How to Wire an Electric Winch on a Utility Trailer
I have a 16’ utility trailer and want to put a winch on the trailer along with a 12v battery to run it. I want to be able to charge the battery while driving. I have a 2011 Ram 1500 with a round 7 pin connection on the rear. Can I use this to...
Troubleshooting Wiring Harness on 2003 Chevy S-10
I just purchased part #118359 wiring harness and trailer connecter for my 2003 Chevy S10. The lights come on and the turn signals work well. However, when I press the brake, all of the lights go out. Can you tell me how to fix the problem?...
Recommended Trailer Hitch Receiver for 2002 Chevy S-10 Truck
I was watching the installation video of a Hidden Hitch 87525 for a 2002 Chevy S10 on Youtube. Is this model no longer available from etrailer.com? I dont see it listed. I have the same vehicle with the same rear bumper depicted in the installation...
Can a Side Marker Trailer light be Wired to Come On with the Blinker
Can I make the side marker ligh blink when the turn signal is on? | If you want to make a side marker light blink with the turn signal it will have to be tapped into the turn signal/brake light wire for that side. But then it will also come...
Draw-Tite Trailer Hitch # 75085 Recommendation for a Chevy S10 Long Bed
I have a 2003 plain base model Chevrolet S10 long bed. Will this hitch fit my truck? I like the extra tow rating and that it does not require removal of the bumper for installation...if this will fit my truck and work without troubles. Thanks...
Recommended Towing Mirrors For 1999 Chevy S-10
Do have a tow mirrors for a 1999 Chevrolet s10 like the one that slip on the OEM mirrors | We have towing mirrors that are confirmed to fit your 1999 Chevrolet S-10 mirrors, but they are not custom. I recommend the K-Source Universal Dual Lens...
How to Wire Curt 4-Pole Wiring Harness # C55411 in a 1996 Chevrolet S10 Pickup
i have an s10 96 model.I am wondering what colors on the trucks wiring harness that i am to attach each color of your wiring to?..i dont have a tester... | The particular 4-pole trailer wiring harness you reviewed, Curt # C55411, is a hard wire...
Truxedo Edge Header Stop For Chevy S-10
Hello i have a 2003 s10 zr5 with a 6 bed. And it came with the truxedo cover and I wanted to know it this would work on my cover, and if i could get seals not sure of the model# or where to find it. | Could you get me pictures of your tonneau...
Curt Class III # 13920 Trailer Hitch for 1997 Chevy S-10 SS Pickup With Roll Pan Bumper
I have a 1997 S-10 SS Chevy pick up. It is a sport truck with a stock rounded back panel where other trucks have a bumper. This truck has no bumper. I went to U-Haul and they were unable to match up a hitch to fit this truck. Can you provide...
Distance from Center of Hitch Pin Hole to Start of Hook on MaxxTow Tow Hook # MT70028
How far is the center of the pin hole from the back of the hook face plate? | I went out to the warehouse to take that measurement on the MaxxTow Tow Hook # MT70028 for you. From the center of the pin hole to plate where the hook starts to come...
Recommended 50 Amp Circuit Breaker for Larin Hitch Lift
Truck S-10 model 2000, single cabin the installation manual request customer to provide for: 1. 50 amp circuit breaker and two 2 6 AWG battery terminals with 5/16 opening. Is this the correct breaker for application? Any recommendation is...
Recommended BedRug Universal Bed Mat for Customized Fit
hello, I found that you may have a brb96ssk full bedrug mats for a 1996-2003 stepside S10, it is exact ? 2002 Chevy S10 Stepside | The BedRug Custom Truck Bed Liner - Full Bed Protection for Trucks with Bare Beds or Spray-In Liners BRB96SSK...
Would the Air Lift Ride Control Air Helper Springs Help Carry a Camper on a 2004 Chevy S-10
i have a 2004 s-10 4 wheel drive im wanting to hull a camper with it. when i put a camper on now i just about drag the ground just wanted to know if one of your products would help me | Using a Air Lift Ride Control Air Helper Spring kit # AL59531...
Which Trailer Hitch Fits 2003 Chevrolet S10 Sportside
What is the difference in a non towing bumper and a roll pan bumper in regards to hitch fit? | Since you have a 2003 Chevy S10 Sportside the correct hitch you need is the # 75085. A roll pan bumper is totally smooth and basically doesn't stick...
How to Figure Out Which Transmission Line is Return Line 1997 Chevy S-10 for Transmission Cooler
On the transmission you have an upper line coming from the radiator to the transmission and a lower line off the radiator to the transmission which hole do they go to on the transmission upper to Upper and Lower to lower? | The best way to determine...
Is the Kenda 4.80-12 Bias Trailer Tire with 12" White Wheel # AM30660 a Load Star Tire
Ordered AM30660 which according to the description was a a Kenda 4.80x12 Load range C tire on a 5x41/2 wheel. The tire I received was correct size but the brand name was Load Star. | The Kenda 4.80-12 Bias Trailer Tire with 12" White Wheel #...
How Can I Tow a 2007 Toyota Prius Behind my RV
I have a 2007 Toyota Prius. Can this vehicle be towed as an RV tag? | The only way your 2007 Toyota Prius can be towed is by using a RoadMaster Tow Dolly with Electric Brakes, part # RM-2050-1. Using the # RM-2000-1 you will not have to mess...
Recommended Replacement Rear Bumper Options For A 1992 Chevy S-10 Pickup
need rear bumper for 92 s10 pickup 2.8l | For your 1992 Chevy S-10 Pickup we have the following bumpers: Chrome # 76000-97200 Black Diamond-Step # 66000-97200 Chrome With Non-Slip Pad # 76001-97200 Black With Non-Slip Pad # 66001-97200 |
Does the Westin Fey Bumper # 66001-97200 Come with a Hole to Access the Spare Tire?
Please verify that this bumper has a hole left of the license plate area to access the spare tire hanger for lowering. Thank you | I have an answer for you. Unfortunately, our installation team here at etrailer confirmed that the Westin Fey...
Replacement Tarp For Extang Tuff Tonneau Cover on 2000 Chevy S10
What is the correct part number for a snapless replacement cover for Extang Tuff Tonneau on a 2000 Chevy S10 with 6 foot bed? | The Extang Tuff you have on your S10 is the 14605. The correct tarp is the Replacement Tarp for Extang Tuff Tonno...
Comparing Westin Fey Black Rear Bumpers For a 1984 Chevrolet S-10
for a 1984 s10 durango 4x4 extended cab...whats the difference between # 61001 and # 66001 | Currently there are 2 black Westin Fey rear bumpers for your 1984 Chevrolet S-10 Durango. The Surestep Rear Bumper # 66001 and the Diamondstep...
Filter Your Search
Contact and Help