!Designer Camper x > !9-7x x > Camper x >

Recommended Pop Up Camper Storage Cover for 2008 Jayco 1207 with AC Unit

We have a 2008 Jayco 1207 with an a/c unit on top that measure 14 inches high. We live in East Tennessee and get a lot of sun and quite a bit of rain. Our camper is stored outside. Can you tell me which cover you recommend? Thanks! | Your 2008...

Recommended Generator Size For A Powering A Coleman AirExcel 8000 Series RV Air Conditioner

I have a 8,000 series roof top a/c on my pop up Camper - what size generator do I need to run the a/c? | You would need a generator capable of providing 30 amp service to the trailer with at least 3600 watts for start up draw of the unit so...

Optronics Low Profile LED RV Tail Light Wire Gauge

What gauge are the wires? | The Low Profile LED RV Tail Light # RVSTLB60 uses 20 gauge wire. |

Replacement Roller for my Slide Out on my 2010 Open Range 385RLS

I have a 2010 385RLS 38foot Open Range fifth wheel trailer. I need to replace the rollers under the bedroom slide. Will these fit? Also, since there is a bolt through the middle of these rollers, are the rollers themselves replaceable at a later...

SportRack Ridge Swing 4 Bike Rack Availability

Do you carry the SportRack ridge swing 4 bike rack Item #SR2415 | The SportRack Ridge Swing 4 Bike Rack # SR2415 is available. As the rack's name implies it swings away - with the bikes loaded - so you can gain access to your vehicle's rear...

License Plate Bracket to Use with Trailer Taillight # 271595

Is there a license plate bracket that I could purchase that would work with your #271595 trailer light? Im planning on purchasing both the driver and passenger lights, but also need the license plate bracket as well. Thanks | When we installed...

Replacement Option For A Jayco Heritage Cascade Entry Door Latch

I am trying to replace the door latch on my Jayco Heritage Cascade, it has the Eberhard latch currently. The dimensions of the opening are 2 3/4foot tall by 3 1/4inch wide, the global link RV latch will not fit. Do have a replacement that...

I Need Propane Tank to Regulator Pigtail with 3/16 ID with Inverted Flare 2 Feet Long

I Need Propane Tank to Regulator Pigtail with 3/16 ID with Inverted Flare 2 Feet Long | I believe what you're looking for is the MB Sturgis Sturgi-Stay Propane Fill Hose part # 100019-24 this has the POL end for the tank side that will thread...

Replacement Knob, Shaft and Screw for a MaxxAir MaxxFan and MaxxFan Deluxe

I find the shaft that i need, MA10-21232KSHAFT, but i also need the knob and the knob screw. I dont find those. Can you point me to the part number? | Yes, I can help you out with that! The correct knob and screw to go with the Replacement...

<< Back to Results

Filter Your Search