2018 Keystone Passport Ultra Lite Elite Travel Trailer RV Camera

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

The Voyager WiSight Wireless RV Backup Camera System #ASA37YR you were looking at is only compatible with the RV Backup Camera #ASA74YRor #WVH100 so this would need to be the camera you already have installed or you would need to replace the…

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do…

Hi Charles, The screws you have in the picture are the ones needed if you were mounting the camera #FOS07TASF into an already mounted shark fin camera mount. If you don't have a prepped trailer with the mounts already in place then…

I have a complete replacement camera system option for you, but since your current camera system is no longer made there are no replacement cameras available that use your same monitor. I recommend replacing it with the Voyager WiSight 2.0 Wireless…

Since your current camera only says Voyager that means it is going to be the 1st generation. The WiSight 2.0 Camera #ASA74YR has Voyager 2.0 on the camera. So you are going want a new system with either the 4.3" Monitor #ASA24YR or…

You can have more than one iPhone "connected" to the Lippert Tire Linc system part #LC37VR but only one can be used at a time. So basically you or your wife could have their phone connected but if you needed to switch between the…

Great question, I did some research into the Furrion Vision S. **Furrion Vision S Wireless RV Observation Camera System w/ 3 LED Marker Light Cameras - 7" #FR98NR. You need not worry about getting any kind of upgrade or anything new to get…

I have attached for you below the pairing procedure for the Voyager WiSight Wireless RV Backup Camera System part #ASA84YR. Please note, a mistake I have made in the past was applying power to the camera too soon, this cannot be done until the…

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is…

If the Forest River Rockwood Mini Lite Travel Trailer came pre-wired then there will be a sharkfin camera mounting bracket at the top of the trailer in the rear. This bracket will then allow you to purchase one of their cameras to use with their…

There isn't an adapter to connect the wiring of a Furrion camera to a Voyager. With that said you can pretty easily just cut the connectors off and then connect to the camera since it's only two wires.