2019 Fleetwood Discovery LXE Motorhome RV Bike Racks

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

We noticed when we installed the etrailer Trailer Hitch Receiver #e98856 on a similar 2022 Jeep Wrangler it had 8" from the center of the hitch pin to the rear edge of the stock spare…

The Hollywood Racks RV Rider #HLY64FR has a frame clamp design that was intended for use with step through style bike frame like what your Aventon Adventure bikes have so this rack would work perfect for you. I attached a picture that shows this…

Your best platform bike rack for spare clearance is the RV Rider part #HLY64FR as it has the most clearance between the hitch pin hole and the wheel trays. This has 12 inches from the pin hole to the pivoting portion of the rack but then has even…

A smaller hitch extender like the Curt part #C45791 would work to give you the additional clearance for your Hollywood Racks RV Rider part #HLY64FR that you need.

The Hollwood Racks #HLY64FR is an excellent choice for most users with an RV towed Jeep Wrangler. If your jeep has a standard size spare on the back, like the one in the picture I have attached, then you can see that you will have plenty of room…

Only certain bike racks are rated for use at the back of an RV or trailer but the Hollywood Racks #HR1400Z bike rack is not one of them. Generally, any rack that can fold or tilt, with few exceptions,…

We have exactly what you need in the Hollywood Racks RV Rider Bike Rack for 2 Electric Bikes, #HLY64FR. This bike rack was designed to carry two bikes on an RV. The RV Rider has an 80 lb. per bike weight capacity so it can be used with e-bikes, has…

There's no difference at all. The #HLY64FR is our unique part number for the Hollywood Racks HR1700 RV Rider bike rack, it's the same…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

There isn't a shorter angled shank for the Jack-It 2 Bike Rack for A-Frame Trailers #LC429756, but there is a straight shank #LC67HD that sits higher that might allow the bikes to sit above the…

In order to use a hitch-mounted bike rack like the Swagman Original #S64152-2 that you were looking at while towing a vehicle, you will just need to add the Roadmaster Dual Hitch Receiver Adapter #RM-077-4. This adapter will slide into the 2 inch…