How To Determine Fit of the Roadmaster Rollaway
Question:
Will this fit my receiver? I have a factory installed hitch and I am not sure the part will fit over the flange.
asked by: Jackie S
Expert Reply:
The collar on your trailer hitch cannot exceed 3-1/4" wide nor can the distance from the center of the hitch pin hole to the end of the receiver tube be more or less than 2-5/16 to 2-7/16" in order for the Roadmaster Rollaway Trailer Hitch Protector part # RM-050 to work on your 2017 Toyota Tacoma.
If your trailer hitch does not meet the above specs you can use the Ultra-Fab Steel Roller part # UF48-979020 instead because it has a much more universal design.
Products Referenced in This Question
Ultra-Fab Steel Roller for RVs with 2" Trailer Hitches
- RV Skid Wheels
- Hitch Mount
- Bolt-On
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Roadmaster Rollaway Trailer Hitch Protector
- RV Skid Wheels
- Hitch Mount
- Bolt-On
- Roadmaster
more information >
Continue Researching
- Q&A: Roadmaster Rollaway Trailer Hitch Protector With Hitch That Has Chain Tabs Below Receiver
- Article: Trailer Wiring Diagrams
- Q&A: Is the Roadmaster Rollaway Trailer Hitch Protector Heavy Duty Enough for Use on a 37 Ft Motor Home
- Q&A: Will Trailer Hitch for 2022 Toyota Sienna Work with Hands Free Liftgate
- Q&A: Bolt-On Skid Wheels Wanted for Underside of Utility Trailer
- Q&A: Recommended Solution For A 2014 Primetime LaCrosse 318 BHS That Scrapes The Ground
- Q&A: Curt vs. etrailer Trailer Hitch For 2025 Kia Carnival
- Q&A: Comparing Curt and etrailer Hitches for a 2024 Toyota Sienna
- Article: Determining Trailer Tongue Weight
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Carrying on a Legacy: One Family’s Story of Grief, Growth, and a Global Pandemic
- Article: How to Raise Your Travel Trailer Height
- Article: Converting Your RV Water Heater to Tankless
- Article: Brake Controller Installation: Starting from Scratch