Keel Roller and Wobble Roller Capacities to Consider when Setting Up a Boat Trailer
Published 09/24/2014 >
Question:
That was good info about the weight rating of the rollers.So if I have the proper rollers for my boat,how do I distribute the weight on the rollers? Do I let most of the weight on the outside rollers or on the keel rollers or should they contact all of the rollers at the same time? Thanks!
asked by: Michael W
Expert Reply:
I spoke to my contact at Yates and he said that you will need to keep in mind the capacities of the keel rollers and wobble rollers and install them accordingly. Keel rollers are rated at 400 lbs and wobble rollers are 200 lbs. So you will need to take the weight of your boat and the capacities of the rollers you plan on using and be sure to use enough.
Some recommend a little more weight on the outside wobble rollers or bunk boards than on the keel rollers to protect the bottom of the hull.
The answer to your second question is no. You will need a longer shaft to add an end cap to your roller.
Product Page this Question was Asked From
Yates Endcap for Boat Trailer Rollers - TPR - 1/2" Shaft - Qty 1
- Boat Trailer Parts
- Rollers
- End Cap
- 2-3/4 Inch Diameter
- Plastic
- Fits 1/2 Inch Shaft
- Yates Rubber
more information >
Continue Researching
- Q&A: Installation Instructions For The Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch
- Q&A: What Are the Differences Between Yellow, Blue and Black Boat Rollers
- Q&A: Replacement 6" x 2" Roller for Older Boat Trailer
- Q&A: How To Measure For Replacement Overhead Springs On A Trailer Door
- Q&A: Replacing Bow Strap and Winch Mount on on Older Shoreline Sailboat Trailer
- Q&A: Solution for a 5 inch Bow Roller Assembly
- Q&A: How to Choose Correct Height for Post-Style Boat Trailer Guide-Ons


Michael W.
9/24/2014
That was good info about the weight rating of the rollers.So if I have the proper rollers for my boat,how do I distribute the weight on the rollers? Do I let most of the weight on the outside rollers or on the keel rollers or should they contact all of the rollers at the same time? Thanks!