bing tracking image
Q & A Icon

Does The Curt # C11423 Fit A 2016 Audi A6 Premium Plus With An S Line Honeycomb Rear Bumper?  

Updated 09/23/2026 | Published 09/20/2026

Question:

Does this fit a 2016 audi a6 premium plus with the s line rear bumper? Mine has the honeycomb valence which I havent seen in any of the reviews. I think the fit should be the same as a non s-line bumper but I am not 100 sure.

0
Audi with Honeycomb Valence
Audi with Honeycomb Valence
(click to enlarge)

Expert Reply:

Hello John,

Welcome to etrailer, I'm glad you found us!

Yes, the Curt Trailer Hitch Receiver # C11423 will fit your 2016 Audi A6 Premium Plus with the S line rear bumper and honeycomb valence.

There is some fascia trimming required for the installation, and with your S line that means trimming the honeycomb portion where the receiver comes through. When you make that cut, I recommend starting slightly smaller than needed and slowly opening it up until you have the clearance you need. A Dremel or fine-tooth cutting tool will give you much better control on that honeycomb plastic than trying to take too much out at once.

You will not have to drill through the vehicle frame, but you will need access through the trunk and the exhaust will need to be temporarily lowered during the install. If your Audi has the hands-free trunk kick sensor, you will also want to pay close attention to the sensor wiring while you are trimming so it does not get damaged.

If you need to pair the hitch with 4-flat wiring for a hitch-mounted accessory with lights or some light towing, you will want the Curt Powered Tail Light Converter with 4-Way Flat Trailer Connector and Install Kit # C59496.

What are you planning on using the hitch for?

expert reply by:
0
Kate F
Hitch Installed on Audi A6
Hitch Installed on Audi A6
(click to enlarge)

Product Page this Question was Asked From