Exterior Light For Fire Department ATV Trailer
Updated 03/26/2026 | Published 03/23/2026 >
Products Featured in This Question
Question:
Would this be able to be mounted on the outside, upper, side of an enclosed trailer to provide work lighting? My fire departments ATV trailer has no lights on the outside which makes it a pain to load and unload at night during responses.
asked by: Kyle S
Expert Reply:
Hi Kyle, I really appreciate what you and your department are doing, my brother is a fireman. The TecNiq D18 Heavy-Duty 24" Scene Light part # TN36CR is a great upgrade for making night loading a lot safer and easier. This TecNiq scene light is designed for exterior mounting, so installing it up high on the side of your enclosed trailer is exactly how it’s meant to be used. From that position, it will cast a wide, bright beam down across your ramp and loading area, which should make a big difference during nighttime responses.
For wiring, it’s a straightforward 12 volt setup with a power and ground, and the most reliable way to run it is off a trailer mounted battery. The black wire is your positive lead and the white wire with the red stripe is your ground. If your trailer has an onboard battery, that’s going to be the best and most dependable way to power this light since it gives you consistent output and doesn’t rely on the tow vehicle being connected.
You would run a fused power wire from the battery to a switch part # 37213405 then from the switch to the light, and ground it to the trailer frame. If you don’t have a battery, you can still use the 7 way from the tow vehicle, but we would want to confirm that the auxiliary power circuit is active. Since it’s going to be exposed to the elements, I would just recommend mounting it in a protected spot or inside a small weatherproof box to keep it sealed up.
If you can let me know whether your trailer already has a battery set up, I can help you dial in the cleanest and most dependable setup for your crew. I am curious though, what do you normally use the ATV for?
Product Page this Question was Asked From
TecNiq D18 Heavy-Duty 24" Scene Light - Premium 8,500 Lumens - 9-14V - White Housing
- Work Lights
- Flood Lights
- Work Lights
- Exterior Lights
- Rectangle
- Surface Mount
- Flood Beam
- LED Light
- White
- TecNiq
more information >
Continue Researching
- Q&A: Replacement For A Dexter 8-249 Hub And Drum Assembly
- Q&A: Looking for Awning Rail for Solera 2000 Awning
- Q&A: Recommended LCD Single Zone Thermostat for Dometic RV Air Conditioners
- Q&A: Would Interior Trailer Lights Be Powered By The 7-Way Connection
- Q&A: How Does Brake Controller Install in 2023 Sprinter Van with 7-Way
- Q&A: Is the Premium Slim LED Strip Light item # TN38ZR a Light Bar?
- Q&A: How To Determine Blue Ox Spring Bar Weight Capacity
- Article: Trailer Wiring Diagrams
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Where to Position the Trailer Axle?




