Do I Need Individual Bilge Heaters For 24' Yamaha Crosswave Jet Skis In Covered Lift During Winter?
Published 09/30/2025
Products Featured in This Question
Question:
My twin 24’ jet skis are stored on a covered lift. Would I need one heater per ski, or could the 600W cover both? new yamaha crosswave waverunners
asked by: Troy
0
Expert Reply:
Troy, each jet ski really needs its own protection. The 400W # XH67FR is usually enough for a single PWC. The 600W # XH77FR could cover a larger bilge, but with two separate skis you’d want one heater per hull. Covers will help retain warmth, but I’d still go with individual 400w heaters.
Do your skis have shore power at the dock, or do you bring them home to plug in?
expert reply by:
Andrew N
0
Product Page this Question was Asked From
Xtreme Heaters RV Basement and Boat Bilge Heater with Quick-Release Bracket - Small - 400 Watts
- RV Heaters
- Electric Heater
- 110 Volts
- Winterization
- 5th Wheel
- Motorhome
- Travel Trailer
- Xtreme Heaters
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Availability Of Furnace That Runs On Propane and Electricity for 2021 StarCraft Autumn Ridge 20FBS
- Q&A: Can Seaflo Fresh Water Electric RV Toilet SE95CR Replace Standard Flush Toilet In 5th Wheel?
- Q&A: Which MORryde Stabilizer is Better? The Hitch or I-Beam Mounted Stabilizer?
- Q&A: Recommended White 15,000 Btu Furrion AC Systems
- Q&A: Can Temperature of Display on Both Vent Assembly and Remote of Furrion Chill Cube for Ducted
- Q&A: Are New R32 AC Units Plug and Play With Old R410A Systems
- Q&A: Wiring Multiple Heating Pads to Switch Diagram
- Article: RV Propane 101: How Does My RV's Propane System Work?