Bright LED Light For Side Of Grand Design Travel Trailer To See Hookup Area
Published 09/11/2025 >
Question:
I want to put one of these gray lights over the hookup side of my Grand Design. Will it throw enough light to see valves and cords at night?
asked by: Connnie
Expert Reply:
Connie, that’s exactly the kind of task the # M388FR was built for. The wedge housing angles the LEDs downward, so you get wide, usable light across your utility area. You’ll be able to see valves, cords, and gear without holding a flashlight, in fact, this might even be overkill which isn't a bad thing!
Are you planning to put it right above the hookups, or offset a bit higher?
Other Grand Design owners - share where you mounted yours for best coverage.
Product Page this Question was Asked From
Exterior LED Utility Light - Flush Mount - Powder Coated Aluminum - Clear Lens - 12/24V DC - Gray
- RV Exterior Lights
- Utility Light
- Hardwired
- Flush Mount
- LED Light
- 12V
- 24V
- Gray
- M-3 and Associates
more information >
Continue Researching
- Q&A: Replacement Lift Motor for MaxxFan 00-04900N
- Q&A: What is the Difference Between Scare Light & Porch Light?
- Q&A: Power Inlet for DIY Build/Ambulance Camper Conversion
- Article: Trailer Hitch Installation Tips
- Q&A: Want To Put Exterior Utility/Loading Light On Back Of Trailer
- Q&A: Why Do Rear Tires on Tandem Horse Trailer Run Hotter Than Those on Front Axle
- Q&A: Replacement for Norcold N811FRT That Fits Existing Opening
- Q&A: Installing a Battery on a Trailer and Wiring it to Run Interior Trailer Lights
- Article: What is Boondocking

