Can I Wire 2 LED RV Exterior Utility Lights To The Same 12v DC Switch?
Published 09/11/2025
Products Featured in This Question
Question:
Can I wire two of these into the same switch, or do they need to be separate?
asked by: Bill
Expert Reply:
Bill, you can wire two fixtures together no problem. Just tie both positives to your switched hot lead and both negatives to ground or negative lead. Since these LEDs draw so little, you won’t overload a typical RV light circuit with a pair of gray lights # M388FR or black lights # M378FR. Are you planning to use them for general patio light or more as work-zone flood lighting?
Other folks reading this - if you’ve doubled these up, how much area did they cover for you?
Product Page this Question was Asked From
Exterior LED Utility Light - Flush Mount - Powder Coated Aluminum - Clear Lens - 12/24V DC - Gray
- RV Exterior Lights
- Utility Light
- Hardwired
- Flush Mount
- LED Light
- 12V
- 24V
- Gray
- M-3 and Associates
more information >
Continue Researching
- Q&A: Power Inlet for DIY Build/Ambulance Camper Conversion
- Q&A: Towing Capacity for a 2001 Dodge Ram 3500
- Article: What is Boondocking
- Q&A: Wiring A 12v Water Pump To A 7-Way Connector
- Q&A: How To Install the Buyers Products 90-Degree Door Check and Hold Back
- Q&A: Availability Of Air Bag Kit For A 2005 Chevy C4500 Kodiak
- Q&A: Recommended Trailer Hitch For A 2000 MCI 40 Foot Intercity Bus
- Q&A: How to Tell if Curt Hitch Will Fit 2008 Ford F-350 Cab and Chassis with Knapheide 6108D54J1 Body