Will Biker Bar Fit 2011 Harley Superglide Custom
Updated 08/15/2025 | Published 07/18/2025
Products Featured in This Question
Question:
Im looking at your biker bar tiedown. I need one for a 2011 harley superglide custom. Im unable to find this in your specs.
asked by: Eric V
Expert Reply:
Hi Eric; B&W doesn't have specific fitment information for a 2011 Harley Superglide Custom. However, you may be able to use the B&W Biker Bar # BWMC2304. To find out if it will fit you will have to take some measurements. A two piece motorcycle tube frame is needed for the Biker Bar to clamp onto. The diameter of each frame tube must be at least 1.125" and no more than 1.5".
Check that there is nothing hanging down below the tube frame, such as a motor, transmission or exhaust. With the rider sitting on the motorcycle, the distance from the side of the frame tubes to the ground must measure between 5" and 6.5".
Also, the distance form the outside edges of each frame tube must be no less than 10" and not more than 14.5". Take this measurement where the Biker Bar will be attached. There must be 1/2" of clearance between the motor, transmission, and primary drive to allow clearance for the Biker Bar clamps.
If you find this won't fit you will need a more traditional setup with a wheel chock. You can use the E-Track # e95VR, Wheel Chock # 3481731, Tie-Down Ring # 59131, and Strap #EM59136 to secure your bike.
(click to enlarge)
Product Page this Question was Asked From
B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson 1-1/2" Custom Frame
- Motorcycle Tie Down Straps
- Trailer
- Clamps
- Tie Down Anchors
- B and W
more information >
Continue Researching
- Q&A: Availability Of Replacement Parts For B&W Biker Bar BWMC2301
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Q&A: What is the Height Adjustment on the B&W Biker Bar Motorcycle Tie-Down Systems?
- Q&A: Is B&W Biker Bar Tie-Down System Compatible with an Indian Chieftain
- Q&A: Replacement Wheel for 15" Lionshead Silver Lynx Trailer Wheel
- Q&A: Adjusting the B&W Biker Bar Base for Height of Road King Frame
- Q&A: Biker Bar Installation and Use with Lowered 2014 HD Ultra Classic
- Q&A: Is There an E-Track Adapter for the B&W Biker Bar
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Choose the Right Trailer Hitch Class
- Article: We Used 34 RV Tow Bars, and These are the Best for Flat Towing
- Article: Trailer Tire Sizing
- Article: Best 5th Wheel to Gooseneck Adapters (2023)
Robin H.
8/15/2025
Hey Eric, did you get a chance to take those measurements for your Harley Superglide Custom? I'm curious if the Biker Bar ended up being a good fit or if you decided to go with the more traditional setup. Let me know how it worked out for you, as it could really help others in a similar situation!