Hayes G2 Brake Boss Trailer Brake Controller Recommendation for a 2011 Jeep Grand Cherokee

Question

Question:

Can I use this on a 2011 Jeep Grand Cherokee with tow package? I dont find a plug in under dash.

asked by: Mike E

0

Expert Reply:

Yes, you can install the Hayes G2 Brake Boss Trailer Brake Controller w/ Mounting Sleeve # HA81792BB in your 2011 Jeep Grand Cherokee. The connector should be mounted on top of the emergency brake bracket, it's gray in color.

Once you find it all you need to do to install this controller is plug the Custom Wiring Adapter for Hayes Brake Controllers # HA81796-HBC into the port under your dash and then plug the other end into the # HA81792BB, mount it, and you'd be good to go.

expert reply by: Jameson C

0

Answer 1

Yes, the Prodigy P3 Brake Controller part #90195 that you referenced can be installed in your 2001 Dodge Ram 2500. All you would need is the correct install harness to plug into the port under your dash. For that you would want part #3020-P. I…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 5

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 8

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Hayes G2 Brake Boss Trailer Brake Controller Recommendation for a 2011 Jeep Grand Cherokee

Products Featured in This Question

Continue Researching