How to Install a Brake Controller in a 2007 Volkswagen Touareg with a Factory 7-Way
Published 06/04/2014
Products Featured in This Question
Question:
I have an 07 Touareg V10 TDI which has a 7 plug at rear of vehicle and factory hitch. I would like to install the Prodigy P2. There is No factory wiring for a brake controller like the earlier and later models. Do have a wiring kit that works for my case? Thanks
asked by: Shawn
Expert Reply:
To install a brake controller in your 2007 Volkswagen Touareg you will need to get some parts from your local Volkswagen dealer. I wish we carried the needed part but we do not. For more information check out the tech bulletin I attached.
The brake controller we recommend the most is the Prodigy P2 Brake Controller part # 90885. This is the best selling controller on the market because of how easy it is to setup and use, and how well it works.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Trailer Wiring Harness For 2005 VW Touareg
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Issues with 2012 VW Touareg 7 Pin Trailer Connector
- Q&A: Troubleshooting Volkswagen Factory 7-way Trailer Connection Issue
- Q&A: Trailer Wiring Harness Fit For 2010 VW Jetta SportWagen TDI
- Q&A: Solution for Needing to Replace Bargman L-400 RV Latch on Travel Trailer
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Curt Trailer Wiring To Replace Older s0601u-r1 Powered Converter
- Article: How to Measure a Trailer Axle