Troubleshooting a Stuck Clamp for an Extang Trifecta
Updated 08/30/2024 | Published 08/26/2024
Products Featured in This Question
Question:
The two clamps that hold down my Trifecta Tonneau cover are extremely tight It take a good bit of strength to lock them over the truck body lip. Is there a way to loosen them? Thanks. Thom. Rogosky
asked by: Thomas R
Expert Reply:
Hey Thomas, the clamp like the part # EX1034 is tight even after unscrewing knob that would mean it's either seized up and would need to be sprayed with some WD-40 to try and release it, or it is somehow binding up to the shaft of the threads. You'll want to gently pry to get it to release, or worst case scenario, replace it with # EX1034 .
Product Page this Question was Asked From
Extang Trifecta Signature 2.0 Soft Tonneau Cover - Folding - Canvas
- Tonneau Cover
- Fold-Up - Soft
- Not Rack Compatible
- Opens at Tailgate
- Tailgate Lock
- Standard Profile - Top of Bed Rails
- Vinyl
- Matte
- Extang
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Cover Does The EX92915-20 Replacement Tarp Fit?
- Q&A: Replacement Tarp for an Extang Trifecta 2.0 Tonneau Cover on a 2012 Toyota Tacoma
- Q&A: Is The Replacement Tarp EX92635-20 For A Long Bed Truck?
- Q&A: Replacement Tarp For An Extang Trifecta Tonneau Cover On A 2009 Toyota Tacoma Access Cab
- Q&A: Weight of 8 Lug Hub and Drum Assembly for 8,000 Pound Axle
- Q&A: Trailer Tire and Wheels for Single Axle 8,000 lb Dump Trailer
- Q&A: Replacement Brake Assembly and Oil Seal for Dexter 00828510 Brake Drums