Vehicle Lights Do Not Work After Installing Curt T-Connector C55486
Updated 10/23/2023 | Published 10/21/2023
Products Featured in This Question
Question:
When its connected my car tail lights dont work how do I get my tail lights to work when I dont need the connector?
asked by: Jonathan
Expert Reply:
Installing a T-Connector, like the Curt # C55486 should not effect the functionality of the vehicles lights whatsoever. The wiring harness will tee into the vehicles wiring harness, giving you separate wiring for a trailer plug, while leaving all of the connections for your vehicles lights in tact. Please go back and make sure all of the plugs on the T-connector are fully inserted with the locking tabs in place. There are a total of 4 plugs (1 male 1 female each side)on the T-connector end so you will need to check all 4 to make sure they are properly connected.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Why Does 4-Pole Wiring Harness Need Direct Battery Power Connection
- Q&A: Recommended Class III Trailer Hitch Receiver For A 1999 Toyota RAV4
- Q&A: Which is Better for Highway Use 4.80-12 or 5.30-12 Trailer TIres
- Q&A: Is The Power Wire Required When Installing The Curt T-Connector Vehicle Wiring Harness # C56350?
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Converting Your RV Water Heater to Tankless
- Q&A: How to Connect a 100 lb. Propane Tank to a 5th Wheel RV
- Q&A: Parts Needed to Connect Two 40 lb Propane Tanks to Stove Top
- Q&A: Trailer Hitch Fit Recommendation for 1988 Toyota 4Runner