Is there Drilling Required to Install the Curt Hitch part # C11824 Mecedez Benz C230 2004
Updated 03/25/2014 | Published 03/22/2014
Question:
Will i have to drill holes for it to fit my Car?
asked by: John S
0
Expert Reply:
Yes, to install the Curt Hitch part # C11824 that you referenced you will need to do some drilling. Temporary bumper removal will be required as well. You will need to use a 7/16 inch drill bit for all of the hole drilling.
I attached a set of installation instructions for you to check out.
expert reply by:
Jameson C
0
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Wiring
- Shop: ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit
- Q&A: Fit of Curt # C11824 Class I Hitch on 2003 Mercedes-Benz C-Class Coupe
- Q&A: Bumper Removal Necessary to Install Curt Class I Hitch on 2003 Mercedes Benz C240
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: Drilling is Needed to Install a CURT Trailer Hitch on a 2006 Mercedes C-230, Can It Handle a Boat
- Q&A: Routing Power Wire to Install Curt # 56146KIT Wiring Harness on 2003 Mercedes-Benz C240 Wagon