Do Bump Stops of 2006 Chevy Malibu Need to be Removed to Install Air Bag Kit
Updated 04/17/2023 | Published 04/16/2023 >
Question:
Do bump stops need to be removed when installing rear air bags
asked by: Mike K
0
Expert Reply:
When installing the Air Lift air bag kit part # AL60776 on your 2006 Chevy Malibu you will need to mostly cut off the bump stop of the vehicle to complete the install. You will end up needing to cut off all but 1/2 of an inch from the cup it installs in. For more info check out the install link I attached to this page as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is Drilling Required for Installation of Coil-Rite Air Helper Springs on a 2009 Nissan Altima
- Q&A: Recommended Flat Tow Setup For 2011 Chevrolet HHR
- Q&A: Will Air Lift 1000 Air Helper Springs Fit 2004 Chevy Malibu

